From: gregory.clement@free-electrons.com (Gregory CLEMENT) Date: Tue, 20 Jun 2017 15:35:53 +0200 Subject: [PATCH] arm64: dts: marvell: mcbin: enable the mdio node In-Reply-To: <20170619073729.8367-1-antoine.tenart@free-electrons.com> (Antoine Tenart's message of "Mon, 19 Jun 2017 09:37:29 +0200") References: <20170619073729.8367-1-antoine.tenart@free-electrons.com> Message-ID: <87o9ti4w92.fsf@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Antoine, On lun., juin 19 2017, Antoine Tenart wrote: > Since the mdio nodes are disabled by default now, we should explicitly > enable these nodes at the board level when they are used. Enable the > cpm_mdio node for the 8040-mcbin. > > Signed-off-by: Antoine Tenart Applied on mvebu/dt64 Thanks, Gregory > --- > > Hi Gregory, > > The series disabling the mdio nodes at the SoC level forgot to enable > the cpm_mdio node for the 8040-mcbin. This is based on mvebu/dt64. > > Thanks, > Antoine > > arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts | 2 ++ > 1 file changed, 2 insertions(+) > > diff --git a/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts b/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts > index fe56efcfcefe..4968e731de61 100644 > --- a/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts > +++ b/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts > @@ -116,6 +116,8 @@ > }; > > &cpm_mdio { > + status = "okay"; > + > ge_phy: ethernet-phy at 0 { > reg = <0>; > }; > -- > 2.9.4 > -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com