From: Peter Korsgaard Date: Tue, 06 Feb 2018 09:45:50 +0100 Subject: [Buildroot] [PATCH v9 2/3] board: vyasa: Add qst5 configuration In-Reply-To: <1517313835-21973-2-git-send-email-jagan@amarulasolutions.com> (Jagan Teki's message of "Tue, 30 Jan 2018 13:03:54 +0100") References: <1517313835-21973-1-git-send-email-jagan@amarulasolutions.com> <1517313835-21973-2-git-send-email-jagan@amarulasolutions.com> Message-ID: <87po5itsjl.fsf@dell.be.48ers.dk> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net >>>>> "Jagan" == Jagan Teki writes: Hi, > This configuration build qt5 along with MALI T76X > for vyasa rk3288 board. > Signed-off-by: Jagan Teki > @@ -29,3 +29,22 @@ You can write this image directly to an SD card device (i.e. /dev/xxx): > $ sudo sync > Finally, you can insert the SD card to the Vyasa RK3288 board, close J4 and boot it. > + > +Testing graphics on Vysa RK3288 > +=============================== > + > +Built Mali T76X, Qt5 and demo application: s/Built/Build/ > + > + $ make amarula_vyasa_rk3288_qt5_defconfig > + $ make > + > +Test procedure: > +- insert require modules > +# modprobe -a rockchipdrm > +# modprobe -a governor_simpleondemand > + > +- build kernel mali driver as module and insert So this defconfig isn't usable out of the box? That isn't really nice :/ How about adding a t76x-mali kernel driver package, similar to E.G. sunxi-mali-driver-mainline: https://patchwork.ozlabs.org/patch/841314/ -- Bye, Peter Korsgaard