From: arno@natisbad.org (Arnaud Ebalard) Date: Sun, 24 Nov 2013 12:52:58 +0100 Subject: [PATCHv2] ARM: mvebu: Add Netgear ReadyNAS 2120 board References: <87ppq5flnb.fsf@natisbad.org> <20131124034951.GY29241@titan.lakedaemon.net> Message-ID: <87y54e819h.fsf@natisbad.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, Jason Cooper writes: > On Tue, Nov 12, 2013 at 08:46:48PM +0100, Arnaud Ebalard wrote: >> >> All hardware parts of the (mv78230 Armada XP based) NETGEAR ReadyNAS >> 2120 are supported by mainline kernel (USB 3.0 and eSATA rear ports, >> USB 2.0 front port, Gigabit controller and PHYs for the two rear ports, >> serial port, LEDs, Buttons, 88SE9170 SATA controllers, three G762 fan >> controllers, G751 temperature sensor) except for: >> >> - the Intersil ISL12057 I2C RTC Chip, >> - the Armada NAND controller. >> >> Support for both of those is currently work in progress and does not >> prevent boot. >> >> Acked-by: Sebastian Hesselbarth >> Signed-off-by: Arnaud Ebalard >> --- > ... >> arch/arm/boot/dts/Makefile | 1 + >> arch/arm/boot/dts/armada-xp-netgear-rn2120.dts | 288 +++++++++++++++++++++++++ >> 2 files changed, 289 insertions(+) >> create mode 100644 arch/arm/boot/dts/armada-xp-netgear-rn2120.dts > > Applied to mvebu/dt Thanks, Jason. Based on the response to the question raised by Jason Gunthorpe regarding PHY compatible string [1], I'll keep in mind to send you a patch at some point (.dts file for RN2120 also has compatible = "marvell,88e1318s") if needed. Cheers, a+ [1]: http://www.spinics.net/lists/arm-kernel/msg288496.html