From: alexander.shishkin@linux.intel.com (Alexander Shishkin) Date: Tue, 05 Jun 2012 17:00:59 +0300 Subject: [PATCH v3 03/12] usb: ehci-hcd: notify phy when connect change In-Reply-To: <1337912665-16615-4-git-send-email-richard.zhao@freescale.com> References: <1337912665-16615-1-git-send-email-richard.zhao@freescale.com> <1337912665-16615-4-git-send-email-richard.zhao@freescale.com> Message-ID: <87y5o197tw.fsf@ashishki-desk.ger.corp.intel.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Richard Zhao writes: > It still has below limitations: > - it does not work for multi-phy ehci > - the best place is after debounce, but I can't get > phy there > > Signed-off-by: Richard Zhao Alan, are you ok with this? > --- > drivers/usb/host/ehci-hcd.c | 14 ++++++++++++++ > 1 files changed, 14 insertions(+), 0 deletions(-) > > diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c > index b100f5f..8c39a7a 100644 > --- a/drivers/usb/host/ehci-hcd.c > +++ b/drivers/usb/host/ehci-hcd.c > @@ -928,6 +928,20 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd) > pstatus = ehci_readl(ehci, > &ehci->regs->port_status[i]); > > + /* FIXME: > + * - it does not work for multi-phy ehci > + * - the best place is after debounce, but I can't get > + * phy there > + */ > + if ((pstatus & PORT_CSC) && ehci->transceiver) { > + if (pstatus & PORT_CONNECT) > + usb_phy_notify_connect( > + ehci->transceiver, i); > + else > + usb_phy_notify_disconnect( > + ehci->transceiver, i); > + } > + > if (pstatus & PORT_OWNER) > continue; > if (!(test_bit(i, &ehci->suspended_ports) && > -- > 1.7.5.4 Regards, -- Alex