Received: from mx3.redhat.com (mx3.redhat.com [172.16.48.32]) by int-mx1.corp.redhat.com (8.11.6/8.11.6) with SMTP id i183cja25256 for ; Sat, 7 Feb 2004 22:38:45 -0500 From: "David Rohrer" MIME-Version: 1.0 Content-Type: multipart/alternative; boundary="----=_NextPart_000_0005_01C3EDCB.079C65A0" Message-ID: Subject: [linux-lvm]LVM Problems Sender: linux-lvm-admin@redhat.com Errors-To: linux-lvm-admin@redhat.com Reply-To: linux-lvm@redhat.com List-Help: List-Post: List-Subscribe: , List-Id: LVM general discussion and development List-Unsubscribe: , List-Archive: Date: Sun Feb 8 17:50:18 2004 List-Id: To: linux-lvm@sistina.com This is a multi-part message in MIME format... ------=_NextPart_000_0005_01C3EDCB.079C65A0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable Content-Disposition: inline I had set up a Red Hat 9.0 Box with no xwindows on it just mainly the basic= install. The /boot, / , and swap are all on HDA....then on HDG and HDH I set up a LV= M during the install. After I filled the drives in the LVM with data I tried to add to more drive= s to it they were HDC and HDD. I'm not the best at this, so I was reading how on the interent...I first t= ried to just do vgextend and it would error, so i done a pvcreate for each = drive and then done a vgextend then I rebooted, I never did a change. so no= w when it boots it errors out trying to mount the volume and I would have t= o go into maintenance and edit the fstab and comment out the volume so it w= ill boot This is what I get when I do a pvscan: pvscan -- reading all physical volumes (this may take a while...) pvscan -- inactive PV "/dev/hdg1" is associated to unknown VG "Volume00" (= run vgscan) pvscan -- inactive PV "/dev/hdh1" is associated to unknown VG "Volume00" (= run vgscan) pvscan -- total: 2 [38.03 GB] / in use: 2 [38.03 GB] / in no VG: 0 [0] And this is what I get from a vgscan: pvscan -- reading all physical volumes (this may take a while...) pvscan -- inactive PV "/dev/hdg1" is associated to unknown VG "Volume00" (= run vgscan) pvscan -- inactive PV "/dev/hdh1" is associated to unknown VG "Volume00" (= run vgscan) pvscan -- total: 2 [38.03 GB] / in use: 2 [38.03 GB] / in no VG: 0 [0] I can send you a vgscan -d if you like but it is quite long, I have data on= the volume and would like to fix it, is there a way to fallback to how it = was before I tried to add the other 2 hard drives? And if so how do I add t= he new ones properly? Thank You Dio There are 3 types of people in the world Those who can count and thos who can't ------=_NextPart_000_0005_01C3EDCB.079C65A0--