From: "Jonathan Baker-Bates" Subject: RE: I have managed to pickle my RAID 1 install after a disk crash Date: Sun, 19 Sep 2004 15:45:02 +0100 Sender: linux-raid-owner@vger.kernel.org Message-ID: References: <414D92CA.2060903@netcetera-solutions.com> Mime-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <414D92CA.2060903@netcetera-solutions.com> To: linux-raid@vger.kernel.org List-Id: linux-raid.ids > -----Original Message----- > From: linux-raid-owner@vger.kernel.org > [mailto:linux-raid-owner@vger.kernel.org]On Behalf Of Dave Dmytriw - > NetCetera > Sent: 19 September 2004 15:08 > To: linux-raid@vger.kernel.org > Subject: I have managed to pickle my RAID 1 install after a disk crash > > > Hi, > > I recently had the mis-fortune of a disk failure, luckily the disk was > part of a RAID1 setup, so nothing was lost - yet...I should mention that > I am mirroring /boot/, swap and / , and am using mdadm. > > I had thought that I had setup grub correctlly to allow booting off of > either disk, but did not test it - my bad. Although it's not any help now, when/if you do get back to the right config, I would use lilo. I tried many times to get grub to work on a RAID 1 config the same as yours (i.e. with /boot mirrored as well) but could not get it to boot from only one disk. Lilo did it no problem though. Jonathan