Received: from smtp.kernel.org (aws-us-west-2-korg-mail-alma10-1.taild15c8.ts.net [100.103.45.18]) (using TLSv1.2 with cipher ECDHE-RSA-AES256-GCM-SHA384 (256/256 bits)) (No client certificate requested) by smtp.subspace.kernel.org (Postfix) with ESMTPS id 47D6F27AC31; Mon, 14 Sep 2026 09:08:03 +0000 (UTC) Authentication-Results: smtp.subspace.kernel.org; arc=none smtp.client-ip=100.103.45.18 ARC-Seal:i=1; a=rsa-sha256; d=subspace.kernel.org; s=arc-20240116; t=1789376884; cv=none; b=csDl9p5ZQ++dj6gHAD/bldlu+fWnIraWXN9F4hKeb0GbbVpQLDklC2nqoOICwloRuHzLH1aU9Uyk6lNVnS2amDHT7Thp0VqxfByCDiwjw6I6iZfH+g9Kkt6Kf/UdnsIpPHbfP25aypqVgjakr2SdFx7vWiD1XX1OoKsnwkTvrXs= ARC-Message-Signature:i=1; a=rsa-sha256; d=subspace.kernel.org; s=arc-20240116; t=1789376884; c=relaxed/simple; bh=9ESsoQKp0q13c/OmvG+uDPEJKk1CQgKUFXsV9CHCjTU=; h=Date:From:To:Cc:Subject:Message-ID:References:MIME-Version: Content-Type:Content-Disposition:In-Reply-To; b=RSN4GdSpa4i3b3EKKtvAMkRUexpyStL2eQKNISTMIDiHK2O5J6DxeVhVW5AiClU8uV88Ad9DcWmxicYtYannJMBj3VhHauR54eCcdVt0nv+HHlqSQml3SzWtx8FCkZqwXvUXUtyijNH6/hbrQ2tQzAX+H3oIR22ARU8SfWDw658= ARC-Authentication-Results:i=1; smtp.subspace.kernel.org; dkim=pass (2048-bit key) header.d=kernel.org header.i=@kernel.org header.b=Y+U9obnw; arc=none smtp.client-ip=100.103.45.18 Authentication-Results: smtp.subspace.kernel.org; dkim=pass (2048-bit key) header.d=kernel.org header.i=@kernel.org header.b="Y+U9obnw" Received: by smtp.kernel.org (Postfix) with ESMTPSA id 00D371F000FF; Mon, 14 Sep 2026 09:07:58 +0000 (UTC) DKIM-Signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=kernel.org; s=k20260515; t=1789376882; bh=x+uFjbeVw45u+g7xjagc3YWrkEsajDX5pecyn3VEm74=; h=Date:From:To:Cc:Subject:References:In-Reply-To; b=Y+U9obnwo78hsDpbfIFvDuqufCr22AYMACPWoXa8ni8Nd7QPm4b5jIy9vuiRFb1hW wBvxaNZATm9xmPUf17r524Vt0QRg2leD20n6fdq22aY2JDwo+kURqzN2VmhKvLCJFM HnWnU63Mi6Eavm9Xx2PWMvbszVZ6CSAlwNm8YbZQ6fVJF7TqShw0N4YZFbV+LRS/SU 7DTczLS9VXxm0cBuUJjp0Dc+Lm+vOECpxS0njKi/WD0O4Oz1evSjwVlmZbjR4gYQ/J 1T/jxS9uKL/34uoa0CGPS56srNQ6ZkFWD92/tj5sUquWxWuxhCMbBETB79HsF2Rvz+ SJ2j95J3U0fUA== Date: Mon, 14 Sep 2026 17:07:55 +0800 From: Zorro Lang To: Christoph Hellwig Cc: fstests@vger.kernel.org, "Martin K. Petersen" , Kanchan Joshi , Anuj Gupta , John Garry , "Darrick J. Wong" , linux-scsi@vger.kernel.org Subject: Re: [PATCH 6/6] generic: test corruption detection using T10 protection information Message-ID: Mail-Followup-To: Christoph Hellwig , fstests@vger.kernel.org, "Martin K. Petersen" , Kanchan Joshi , Anuj Gupta , John Garry , "Darrick J. Wong" , linux-scsi@vger.kernel.org References: <20260911070831.1760646-1-hch@lst.de> <20260911070831.1760646-7-hch@lst.de> Precedence: bulk X-Mailing-List: fstests@vger.kernel.org List-Id: List-Subscribe: List-Unsubscribe: MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: <20260911070831.1760646-7-hch@lst.de> On Fri, Sep 11, 2026 at 09:08:24AM +0200, Christoph Hellwig wrote: > Add a test that simulates bit flips in data and misdirected writes and > checks that file systems detect it when run on devices using protection > information. > > This requires the new scsi_debug corruption injection. > > Signed-off-by: Christoph Hellwig > Reviewed-by: "Darrick J. Wong" > --- Looks good to me, Reviewed-by: Zorro Lang > tests/generic/2302 | 133 +++++++++++++++++++++++++++++++++++++++++ > tests/generic/2302.out | 21 +++++++ > 2 files changed, 154 insertions(+) > create mode 100755 tests/generic/2302 > create mode 100644 tests/generic/2302.out > > diff --git a/tests/generic/2302 b/tests/generic/2302 > new file mode 100755 > index 000000000000..fd83c64dfff1 > --- /dev/null > +++ b/tests/generic/2302 > @@ -0,0 +1,133 @@ > +#! /bin/bash > +# SPDX-License-Identifier: GPL-2.0 > +# Copyright (c) 2026 Christoph Hellwig > +# > +# FS QA Test No. 2302 > +# > +# Test that T10 DIF detects bitflips and misplaced writes. > +# > +. ./common/preamble > +_begin_fstest auto rw pi > + > +_cleanup() > +{ > + cd / > + rm -r -f $tmp.* > + [ -d "$SCSI_DEBUG_MNT" ] && _unmount $SCSI_DEBUG_MNT 2>/dev/null > + _put_scsi_debug_dev > +} > + > +. ./common/scsi_debug > +. ./common/filter > + > +_require_debugfs > +_require_scsi_debug > +# If TEST_DEV is block device, make sure current fs is a localfs which can be > +# written on scsi_debug device > +_require_test > +_require_block_device $TEST_DEV > +_require_xfs_io_command fiemap > +_require_odirect > + > +# FIEMAP on Btrfs returns logical addresses within the filesystem's address > +# space, not physical device offsets. Writing to these offsets on $SCRATCH_DEV > +# would corrupt the filesystem in multi-device setups. > +_exclude_fs btrfs > + > +size=$(_small_fs_size_mb 256) > + > +test_dif() > +{ > + local pi_type=$1 > + local last=$2 > + local bit_errors=$3 > + local reftag_adjust=$4 > + > + echo -n "Testing DIF type $pi_type " > + if [ "$bit_errors" -gt "0" ]; then > + echo -n "bit errors ($bit_errors) in " > + fi > + if [ "$reftag_adjust" -ne "0" ]; then > + echo -n "reftag adjustment by $reftag_adjust in " > + fi > + if [ "$last" -eq 1 ]; then > + echo "last sector" > + else > + echo "first sector" > + fi > + > + scsi_debug_pi_opts="write_same_length=0 dif=${pi_type} dix=1" > + SCSI_DEBUG_DEV=`_get_scsi_debug_dev 512 512 0 $size $scsi_debug_pi_opts` > + > + local integrity_path="$(_sysfs_block_integrity_path $SCSI_DEBUG_DEV)" > + if [ ! -d "$integrity_path" ]; then > + _notrun "DIF not supported by running kernel" > + fi > + > + SCSI_DEBUG_MNT="$TEST_DIR/scsi_debug_$seq" > + rm -rf $SCSI_DEBUG_MNT > + mkdir $SCSI_DEBUG_MNT > + > + _mkfs_dev $SCSI_DEBUG_DEV || \ > + _fail "Can't make $FSTYP on DIF-enabled scsi_debug device" > + run_check _mount $SCSI_DEBUG_DEV $SCSI_DEBUG_MNT > + > + local blksz=$(_get_block_size $SCSI_DEBUG_MNT) > + local testfile="$SCSI_DEBUG_MNT/test" > + > + $XFS_IO_PROG -d -f \ > + -c "pwrite -S 0x66 0 $((128 * blksz))" \ > + -c fsync \ > + $testfile >> $seqres.full 2>&1 > + > + local phys_sector=$(_get_file_extent_sector $testfile 0) > + if [ -z "$phys_sector" ]; then > + _fail "$test_name: failed to get physical block offset via fiemap" > + fi > + > + local dev=$(_short_dev $SCSI_DEBUG_DEV) > + local debugfs_dir=$(ls /sys/block/$dev/device/scsi_device/) > + local debugfs_file="/sys/kernel/debug/scsi_debug/$debugfs_dir/corrupt" > + > + if [ ! -f "$debugfs_file" ]; then > + _notrun "scsi_debug corruption injection not supported" > + fi > + > + if [ "$last" -eq 1 ]; then > + echo "adding to $phys_sector" >> $seqres.full > + phys_sector=$((phys_sector + (128 * blksz / 512) - 1)) > + fi > + > + echo "lba=$phys_sector,num=1,bit_errors=$bit_errors,reftag_adjust=$reftag_adjust" \ > + > $debugfs_file > + > + $XFS_IO_PROG -d -f \ > + -c "pread 0 $((128 * blksz))" \ > + $testfile > + > + [ -d "$SCSI_DEBUG_MNT" ] && _unmount $SCSI_DEBUG_MNT 2>/dev/null > + _put_scsi_debug_dev > +} > + > +# test data corruption in first block > +test_dif 1 0 2 0 > +test_dif 2 0 2 0 > +test_dif 3 0 2 0 > + > +# test data corruption in last block > +test_dif 1 1 2 0 > +test_dif 2 1 2 0 > +test_dif 3 1 2 0 > + > + > +# Note: Type 3 doesn't have a reftag, so don't test it > + > +# reftag mismatch in first block > +test_dif 1 0 0 8 > +test_dif 2 0 0 8 > + > +# reftag mismatch in last block > +test_dif 1 1 0 8 > +test_dif 2 1 0 8 > + > +_exit 0 > diff --git a/tests/generic/2302.out b/tests/generic/2302.out > new file mode 100644 > index 000000000000..03b68d904943 > --- /dev/null > +++ b/tests/generic/2302.out > @@ -0,0 +1,21 @@ > +QA output created by 2302 > +Testing DIF type 1 bit errors (2) in first sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 2 bit errors (2) in first sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 3 bit errors (2) in first sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 1 bit errors (2) in last sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 2 bit errors (2) in last sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 3 bit errors (2) in last sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 1 reftag adjustment by 8 in first sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 2 reftag adjustment by 8 in first sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 1 reftag adjustment by 8 in last sector > +pread: Invalid or incomplete multibyte or wide character > +Testing DIF type 2 reftag adjustment by 8 in last sector > +pread: Invalid or incomplete multibyte or wide character > -- > 2.53.0 >