From: Eugen.Hristev at microchip.com Date: Thu, 11 Feb 2021 07:28:15 +0000 Subject: [PATCH] ARM: dts: at91: sama7g5ek: enable pull-up for serial debug line In-Reply-To: <20210128081411.1139971-1-eugen.hristev@microchip.com> References: <20210128081411.1139971-1-eugen.hristev@microchip.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 28.01.2021 10:14, Eugen Hristev wrote: > If the serial tx/rx are floating, it can happen that bogus characters > are detected on the line at boot time. This leads to U-boot accidentally > thinking someone pressed a key to stop autoboot, thus stopping booting process. > This can happen if the serial cable is not connected. There are hardware > pull-ups on the board connected to serial cable VBUS. > To solve this when the cable is not plugged, enable internal pull-ups as well > for the tx/rx lines. > > Signed-off-by: Eugen Hristev > --- > arch/arm/dts/sama7g5ek.dts | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/arch/arm/dts/sama7g5ek.dts b/arch/arm/dts/sama7g5ek.dts > index ff9c9eb45c..3a4fdd38a5 100644 > --- a/arch/arm/dts/sama7g5ek.dts > +++ b/arch/arm/dts/sama7g5ek.dts > @@ -122,7 +122,7 @@ > pinctrl_flx3_default: flx3_default { > pinmux = , > ; > - bias-disable; > + bias-pull-up; > }; > > pinctrl_sdmmc0_cmd_data_default: sdmmc0_cmd_data_default { > Applied to u-boot-atmel/master