From: =?GB2312?B?zNq3ycH6?= Date: Tue, 3 Jan 2006 17:52:51 +0800 Subject: [U-Boot-Users] =?GB2312?B?u9i4tDogcHBjXzR4eC1sZDogdS1ib290OiBOb3QgZW5vdWdoIHJvb20g?= =?GB2312?B?Zm9yIHByb2dyYW0gaGVhZGVycyAoYWxsb2NhdGVkIDIsIG5lZWQgMyk=?= In-Reply-To: <20060103082113.A893F3540BC@atlas.denx.de> References: <20060103082113.A893F3540BC@atlas.denx.de> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Thank u! I just want to make a test before i modify content of files such as ep405.c . and i changed the directory as you said to board/ and modified the Makefile correctly. then , #make clean #make ep405_config #make all the error followed is : make[1]: Entering directory `/tmp/u-boot-1.1.4/board/ep405' make[1]: *** No rule to make target `../common/misc.c', needed by `.depend'. Stop. so now, where will i check the rule and do some amendments and how to do? I also confused by another problem: There has been a PlanetCore Boot Loader resides in flash memoery(in EP405),and there is no JTAG on the board. so if i erase the existed bootloader which is convinient for writing flash, it will be difficult for me to write my u-boot image to flash. so can i keep the existed bootloader and as it is now and use it to write u-boot in another region of the flash ? Then after booting from PlanetCore Boot Loader, i will be able to run u-boot and check if it has been correctly modified. if the answer is yes, what should i do during the procedure of modifying u-boot? 2006/1/3, Wolfgang Denk : > In message you wrote: > > > > Thank you so much for answering my questions i mentioned several days > = > > ago. > > I'm porting u-boot-1.1.4 to Ebedded planet EP405(with ppc 405GPr > > processor) and it bases on a similar board CPCI4052 as you suggested. > > Let's keep in mind that similar does not mean the same. > > > #cd ../u-boot-1.1.3/board/esd > > #mkdir ep405 > > This is wrong. Don't do this. "board/esd" is for boards manufactured > by esd electronics only, while the EP405 is by Embedded Planet. So > far we don't have a vendor directory for EP, which means you have to > place your code in board/ > > > then add text content as follow to u-boot-1.1.3/Makefile > > ep_config: unconfig > > @./mkconfig $(@:_config=) ppc ppc4xx cpci405 esd > > Wrong again, as you must provide your own board config file instead of using > the cpci405 one. > > > would you please tell me why and how to handle it ? > > Clean up above problems first, please. > > Best regards, > > Wolfgang Denk > > -- > Software Engineering: Embedded and Realtime Systems, Embedded Linux > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de > Things that try to look like things often do look more like things > than things. Well-known fact. - Terry Pratchett, _Wyrd Sisters_ >