From: Joris Offouga Date: Thu, 14 Feb 2019 14:43:58 +0100 Subject: [U-Boot] [PATCH v2] warp7: README: Adjust the binary name after DM conversion In-Reply-To: <20190209140159.15669-1-festevam@gmail.com> References: <20190209140159.15669-1-festevam@gmail.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="utf-8" Content-Transfer-Encoding: 8bit To: u-boot@lists.denx.de Le 09/02/2019 à 15:01, Fabio Estevam a écrit : > After the conversion to DM the U-Boot binary is called u-boot-dtb.imx, > so fix the README file accordingly. > > Signed-off-by: Fabio Estevam > --- > Changes since v1: > - Fix all occurrances > > board/warp7/README | 12 ++++++------ > 1 file changed, 6 insertions(+), 6 deletions(-) > > diff --git a/board/warp7/README b/board/warp7/README > index 60339da543..579bb2de38 100644 > --- a/board/warp7/README > +++ b/board/warp7/README > @@ -17,7 +17,7 @@ $ make mrproper > $ make warp7_config Hi Fabio Fix typo warp7_config into warp7_defconig > $ make > > -This will generate the U-Boot binary called u-boot.imx. > +This will generate the U-Boot binary called u-boot-dtb.imx. > > Put warp7 board in USB download mode: > > @@ -28,11 +28,11 @@ Connect a USB to serial adapter between the host PC and warp7 > > Connect a USB cable between the OTG warp7 port and the host PC > > -Copy u-boot.imx to the imx_usb_loader folder. > +Copy u-boot-dtb.imx to the imx_usb_loader folder. > > -Load u-boot.imx via USB: > +Load u-boot-dtb.imx via USB: > > -$ sudo ./imx_usb u-boot.imx > +$ sudo ./imx_usb u-boot-dtb.imx > > Then U-Boot should start and its messages will appear in the console program. > > @@ -46,9 +46,9 @@ Use the default environment variables: > Run the DFU command: > => dfu 0 mmc 0 > > -Transfer u-boot.imx that will be flashed into the eMMC: > +Transfer u-boot-dtb.imx that will be flashed into the eMMC: > > -$ sudo dfu-util -D u-boot.imx -a boot > +$ sudo dfu-util -D u-boot-dtb.imx -a boot > > Then on the U-Boot prompt the following message should be seen after a > successful upgrade: