From: Marek Vasut Date: Tue, 18 Jun 2019 22:20:02 +0200 Subject: [U-Boot] [PATCH] spl, Makefile: Take external offset into account for fit images In-Reply-To: <20190618201320.25891-1-sjoerd.simons@collabora.co.uk> References: <20190618201320.25891-1-sjoerd.simons@collabora.co.uk> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 6/18/19 10:13 PM, Sjoerd Simons wrote: > When building a FIT image for SPL to load also take into account the > configured external offset. This allows the SPL to load the u-boot FIT > image correctly when configuring SECURE_BOOT on i.mx6 is enabled > (with CONFIG_FIT_EXTERNAL_OFFSET=0x3000). > > Note this doesn't allow secure booting; but it does allow an unsigned > SPL/u-boot with secure boot support eanbled to boot on open device. Does this change behavior on systems which don't use CONFIG_FIT_EXTERNAL_OFFSET ? > Signed-off-by: Sjoerd Simons > > --- > > Makefile | 1 + > 1 file changed, 1 insertion(+) > > diff --git a/Makefile b/Makefile > index c55ffa265f..a8808aeefd 100644 > --- a/Makefile > +++ b/Makefile > @@ -1240,6 +1240,7 @@ endif > ifdef CONFIG_SPL_LOAD_FIT > MKIMAGEFLAGS_u-boot.img = -f auto -A $(ARCH) -T firmware -C none -O u-boot \ > -a $(CONFIG_SYS_TEXT_BASE) -e $(CONFIG_SYS_UBOOT_START) \ > + -p $(CONFIG_FIT_EXTERNAL_OFFSET) \ > -n "U-Boot $(UBOOTRELEASE) for $(BOARD) board" -E \ > $(patsubst %,-b arch/$(ARCH)/dts/%.dtb,$(subst ",,$(CONFIG_OF_LIST))) > else > -- Best regards, Marek Vasut