From: Michal Simek Date: Thu, 12 Mar 2020 12:44:30 +0100 Subject: ZynqMP boot: no messages from SPL other than "Debug uart enabled" In-Reply-To: <69846a06-7085-70dd-bde1-95abf870cd73@gmail.com> References: <0f9a6b47-110c-c2f8-ec40-72106ed3272d@xilinx.com> <77460fd1-f86d-fd53-66af-28d16fe395a1@gmail.com> <4fcae7a6-1156-d868-3463-424368cf7b7f@xilinx.com> <69846a06-7085-70dd-bde1-95abf870cd73@gmail.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi, On 12. 03. 20 12:38, Major A wrote: > Hi Michal, > >> First of all I sent v2 because of dt changes to see 1.1 revision and I >> have also tested it on real HW. > > Just tried your patch v2 against mainline master branch, it still > doesn't work on my board.? I also checked your mainline-v20200312 > branch, it's exactly the same: no output from any UART other than "Debug > uart enabled" on UART0 if I enable it in menuconfig as "early UART". then you can add some more prints to see where it stucks. > >>> For some reason, that's no enough: I have to manually set >>> CONFIG_DEVICE_TREE because xilinx_zynqmp_virt_defconfig sets it wrong. >>> In any case, behaviour is exactly the same as before. >> >> With latest my queue it should be enough. >> https://github.com/michalsimek/u-boot/tree/mainline-v20200312 > > It's the same.? CONFIG_DEFAULT_DEVICE_TREE becomes "zynqmp-zcu100-revC" > whatever I do, there is no trace of the value specified in the > DEVICE_TREE environment variable. export DEVICE_TREE=... should cause that CONFIG_DEFAULT_DEVICE_TREE will remain assigned to zcu100 but SPL/u-boot proper will be using zcu102. You can check it by looking at build folder ls spl/board/xilinx/zynqmp/ where you see which psu_init was used (recommend to make mrproper before you check this to remove old builds) $ ls spl/board/xilinx/zynqmp/ built-in.o pm_cfg_obj.o tap_delays.o tap_delays.su zynqmp.o zynqmp.su zynqmp-zcu102-rev1.1 > >> But I think that latest mainline should setup default in ITS properly. >> You can check it by looking at u-boot.its when build is done and find >> default configuration option which should point to 1.1 dt. > > From the build using your mainline-v20200312 branch: > > ? default = "config_1"; > > where config_1 is > > ? description = "avnet-ultra96-rev1"; > You should look at this. configurations { default = "config_17"; config_17 { description = "zynqmp-zcu102-rev1.1"; firmware = "atf"; loadables = "uboot"; fdt = "fdt_17"; }; Thanks, Michal