From: Dan Malek Date: Wed, 18 Jan 2006 16:29:12 -0500 Subject: [U-Boot-Users] U-Boot on ARMEB In-Reply-To: <43CEAD65.6070609@precidia.com> References: <43CE974F.6020206@precidia.com> <641ab094cf8ec93ba785008fc15578ea@embeddedalley.com> <43CEAD65.6070609@precidia.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Jan 18, 2006, at 4:04 PM, Brian White wrote: > That's what I'm figuring out, but it tried to create a link from > "asm-arm" and I wasn't sure if there were endian dependencies there. > Can I just link it to "asm-armeb" and have it work? All I did was build some cross tools, called them armeb-gcc, etc. Then: setenv ARCH arm setenv CROSS_COMPILE armeb- make ixdp425_config make and ended up with a big endian U-Boot. I started hacking from there and haven't seen any problems. If there are any, we have not found them yet. > I think I'm just going to link all my tools so they're available as > both "armeb-linux" and "arm-linux". My worry is that something will > be specifically little-endian somewhere and will be quietly compiled > incorrectly. I think you worry too much, and naming the same tool by those two different names would seem to be more of a problem than doing it properly. If the tools are built correctly for big endian ARM, it seems everything works fine. I have no further comments on the subject. Good Luck. :-) -- Dan