From: Marek Vasut Date: Fri, 28 Jun 2019 02:07:17 +0200 Subject: [U-Boot] [PATCH v1 06/11] mmc: if possible, poll the busy state using DAT0 In-Reply-To: <20190627103140.16505-7-jjhiblot@ti.com> References: <20190627103140.16505-1-jjhiblot@ti.com> <20190627103140.16505-7-jjhiblot@ti.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 6/27/19 12:31 PM, Jean-Jacques Hiblot wrote: > Using the DAT0 line as a rdy/busy line is an alternative to reading the > status register of the card. It especially useful in situation where the > bus is not in a good shape, like when modes are switched. > This is also how the linux driver behaves. > > Signed-off-by: Jean-Jacques Hiblot Is this documented somewhere that this is an OK thing to do ? If the bus is not in a good shape, what guarantee do we have that DAT0 (part of the bus ;-) ) would be in good shape ? -- Best regards, Marek Vasut