From: Joel Date: Fri, 29 Aug 2003 09:57:44 +0000 Subject: Re: [LARTC] where do i start? Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Van .... You need to see http://docum.org it has good examples. and the masters guide is at http://lartc.org joel On Fri, 2003-08-29 at 14:34, van wrote: > to everyone, > > hi people, am new with this things(advance routing/traffic control). > my query is this, i will be testing out this setup. > i have already bridge a 2-port ethernet card(ex eth2, eth3), not > physically assigning any ip address to this ports. the bridge was > assigned with an ip instead. now, my problem is controlling > bandwidth of traffic flowing on the ethernet port(ex eth3) which is > based from the routing made on the machine(for example i have routed 3 > diferrent ip blocks to pass thru the ether). how will i set limit to > traffic used per individual ip block(ex. 1st ip block limited to 1MB > of traffic, 2nd ip block limited to 2MB of traffic, 3rd ip block > limited to 3MB of traffic). > > any links, websites, documents and knowledge you might share will be > very highly appreciated.. > > thanks > van _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/