From: Takashi Iwai Subject: Re: Swissonic TS22PCI / Teratec Phase 22 / driver problems with ice1724 Date: Thu, 14 Aug 2008 16:13:45 +0200 Message-ID: References: <48A4332E.4070704@kanal-ratte.de> <48A43A2A.7050701@kanal-ratte.de> <48A43C11.10904@kanal-ratte.de> Mime-Version: 1.0 (generated by SEMI 1.14.6 - "Maruoka") Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: Received: from mx2.suse.de (ns2.suse.de [195.135.220.15]) by alsa0.perex.cz (Postfix) with ESMTP id 68C6524719 for ; Thu, 14 Aug 2008 16:13:45 +0200 (CEST) In-Reply-To: <48A43C11.10904@kanal-ratte.de> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: alsa-devel-bounces@alsa-project.org Errors-To: alsa-devel-bounces@alsa-project.org To: Manuel Schneider Cc: alsa-devel@alsa-project.org List-Id: alsa-devel@alsa-project.org At Thu, 14 Aug 2008 16:07:13 +0200, Manuel Schneider wrote: > > Takashi Iwai schrieb, Am 14.08.2008 16:03: > > > At Thu, 14 Aug 2008 15:59:06 +0200, > > Manuel Schneider wrote: > >> Takashi Iwai schrieb, Am 14.08.2008 15:47: > >> > >>> Pass model=phase22 module option to snd-ice1724 driver. Then it > >>> handles the card as if it's phase22. > >> Thanks for this hin. Unfortunately it changes nothing - still kernel > >> error message, still no usable sound device. > > > > Are you sure? With the proper model name, at least you won't get > > EEPROM version error any more. > > > yes, pretty sure. I just reverted my patch and recompiled the driver to > check it out: > > ice1712: cannot initialize pro ac97, skipped > ice1724: No matching model found for ID 0x3b157b11 This means that you didn't pass the model option properly. > ice1724: Invalid EEPROM version 0 > AC'97 0 does not respond - RESET > AC'97 0 access is not valid [0xffffffff], removing mixer. > ice1712: cannot initialize pro ac97, skipped > > > >> I also tried the following kernel patch, which gives me an accessible > >> sound device and usable mixer (and no kernel error), but recording does > >> not work (just noise). > > > > Likely an incompatible hardware design for the recording... > > I guess it's another firmware... The board has no firmware to load. > I can't test playback as I only have > remote access to the server and it is only used for recording > (streaming) but I assume it does also not work. > I admit that this patch was just a hack to try it out. First you should check whether the exactly same codec chip, AK4524, on it. Takashi