Skip to contentSkip to conversation

u-boot, 8548 and gdb

U-Boot-Users Charles J Gillan 1 participant 1 message May 8, 2006

lore
Share & tools
lore
#0 lore raw

I am trying to debug U-Boot on an 8548 based board.

The tool chain is from ELDK 4.0 and I am using a BDI2000.

Up to now have used the TI instruction to step through the assembler line by line with the BDI2000. I am now at

board_init_f

and want to start using gdb to speed things up.

However when rebooting the board and connecting gdb I get an unexpected result. The code is not at 0xfffffffc as expected:

[root at d6157 u-boot-27-apr-2006]# ppc_85xx-gdb u-boot

GNU gdb Red Hat Linux (6.3.0.0-1.21_1rh)
Copyright 2004 Free Software Foundation, Inc.
GDB is free software, covered by the GNU General Public License,

This GDB was configured as "--host=i386-redhat-linux

                               --target=ppc-linux"...

(gdb) target remote xxx.xxx.xxx.xxx:2001

Remote debugging using xxx.xxx.xxx.xxx:2001

0xd8f61fc2 in ?? ()

(gdb)

while the terminal window connected to the BDI2000 has the following:

ipax8548E_ubt>info

      Target CPU        : MPC8548 Rev.1
      Target state      : halted
      Debug entry cause : unknown
      Current PC        : 0xfffffffc
      Current CR        : 0x00000000
      Current MSR       : 0x00000000
      Current LR        : 0x00000000
      Current CCSRBAR   : 0x0_ff700000

ipax8548E_ubt>

The BDI config file contains the following:

[INIT]
WM32 0xFF7E0F08 0x00000008 ;Clear bit 30 in the engineering only
register

                                ;(CCSR space register at offset 0xe0f08)

WSPR 1009 0x00001000 ; Enable ABE bit see Errata for 8548E Rev 1

WSPR 63 0xffff0000 ; IVPR to boot core
WSPR 415 0x0000f000 ; IVOR15 - debug exception

[TARGET]

CPUTYPE     8548        ;the CPU type
JTAGCLOCK   2           ;use 4 MHz JTAG clock - needed for Flash.
STARTUP     HALT        ;halt core while HRESET is asserted
BREAKMODE   HARD      	;SOFT or HARD, HARD uses PPC hardware breakpoint
STEPMODE    HWBP        ;JTAG or HWBP, HWBP uses a hardware breakpoint
WAKEUP      500         ;give reset time to complete
POWERUP     5000        ;start delay after power-up detected in ms

Is there anything obvious that is wrong here ?

Thanks,

Charles.

------------------------------------------------------------------------
?
Dr Charles J Gillan
The Institute of Electronics, Communications and

       Information Technology (ECIT),???????????????

Queen's University Belfast, Titanic Quarter
Queen?s Road, Queen?s Island, Belfast, BT3 9DT
Northern Ireland, UK
?
Tel: +44 (0) 2890 971847
Fax: +44 (0) 2890 971702
??
------------------------------------------------------------------------