"/boot" under LVM2 support in lilo or grub
Hello there everyone.
I found from poking around the web that lilo, in theory, supports having "/boot" under LVM2 control rather then existing as its own partition.
I was wondering if anyone can confirm or deny this. And if anyone has any docs on how to configure or setup this up.
Thanks!
Quoted 1 line · Greg Hartzog
I found from poking around the web that lilo, in theory, supports having �/boot� under LVM2 control rather then existing as its own partition.
this would be really nice to see. Most FAQs advise you to partition your
disk. But my PV is about 5TB, which stupid DOS partitioning can't handle
anyway. I think it should be possible to have a small LV containing
the /boot directory. With my PE size of 32M, I don't even have to worry
if it is contiguous, as it will fit into a single PE. The very first
sector of a PV seems to be unused by LVM, thus a Lilo or Grub MBR may be installed. The remaining problem is to set up the mapping for LILO or Grub to load further stages and the kernel itself.
I looked into the LILO sources and indeed found some fragments dealing with LVM when trying to get the physical sector numbers of the files to load (using FIBMAP). But I'm still searching where this is documented.
The Grub development seems to be focused mainly on wired mutiboot problems with DOS and Windows XY. The whole system fundamentally depends on the concept of a partition table to solve problems I will never have :-)
Dieter.
Quoted 5 lines · Dieter St�ken
Quoted 1 line · Greg Hartzog
I found from poking around the web that lilo, in theory, supports having ?/boot? under LVM2 control rather then existing as its own partition.
this would be really nice to see. Most FAQs advise you to partition your disk. But my PV is about 5TB, which stupid DOS partitioning can't handle
L.
Signature · 6 lines
Luca Berra -- [email protected] Communication Media & Services S.r.l. /"\ \ / ASCII RIBBON CAMPAIGN X AGAINST HTML MAIL / \
My thanks to everyone for answering.
From the lilo author, I found that my choices are for "/boot" to either be on RAID-1 or to be under LVM. But both are not allowed.
So I am considering what to do next.
What is the state of the LVM mirroring code? Could I create mirrored logical volumes in LVM rather then putting LVM on top of RAID-1 md?
Thanks!
_____
From: [email protected] [mailto:[email protected]] On Behalf Of Greg Hartzog
Sent: Wednesday, May 17, 2006 10:09 AM
To: [email protected]
Subject: [linux-lvm] "/boot" under LVM2 support in lilo or grub
Hello there everyone.
I found from poking around the web that lilo, in theory, supports having "/boot" under LVM2 control rather then existing as its own partition.
I was wondering if anyone can confirm or deny this. And if anyone has any docs on how to configure or setup this up.
Thanks!
Quoted 7 lines · Greg Hartzog
My thanks to everyone for answering.
Quoted 1 line
From the lilo author, I found that my choices are for "/boot" to either be
on RAID-1 or to be under LVM. But both are not allowed.
it depends on what you intend for raid1
the lilo device mapper patch only supports linear maps, so you cannot use it with dm-mirror. but /boot over lvm over md always worked fine.
L.
Signature · 6 lines
Luca Berra -- [email protected] Communication Media & Services S.r.l. /"\ \ / ASCII RIBBON CAMPAIGN X AGAINST HTML MAIL / \