scsi problem with usb
Hi,
I am using linux 2.6.17 for my usb controller driver in host mode for mass storage emulation. Mass storage device is detected and I got following prints
/ # INQUIRY message sent
Vendor: Generic Model: Flash D Rev:
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sdb: 1024 512-byte hdwr sectors (1 MB)
sdb: Write Protect is off
sdb: assuming drive cache: write through
SCSI device sdb: 1024 512-byte hdwr sectors (1 MB)
sdb: Write Protect is off
sdb: assuming drive cache: write through
sdb:<7>usb-storage: queuecommand called
unknown partition table
sd 1:0:0:0: Attached scsi removable disk sdb
sd 1:0:0:0: Attached scsi generic sg1 type 0
INQUIRY message sent
Vendor: Generic Model: AUTORUN Disk Rev: 8.00
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sdc: 1024 512-byte hdwr sectors (1 MB)
sdc: Write Protect is on
sdc: assuming drive cache: write through
SCSI device sdc: 1024 512-byte hdwr sectors (1 MB)
sdc: Write Protect is on
sdc: assuming drive cache: write through
sdc:<7>usb-storage: queuecommand called
sdc1 sdc4
sd 1:0:0:1: Attached scsi disk sdc
sd 1:0:0:1: Attached scsi generic sg2 type 0
crw-r--r-- 1 root root 5, 1 Jan 1 00:01 console
crw-r--r-- 1 root root 29, 0 May 11 2006 fb0
crw-r--r-- 1 root root 89, 0 May 11 2006 i2c-0
crw-r--r-- 1 root root 89, 1 May 11 2006 i2c-1
crw-r--r-- 1 root root 1, 1 May 11 2006 mem
crw-r--r-- 1 root root 90, 0 May 11 2006 mtd0
crw-r--r-- 1 root root 1, 3 May 11 2006 null
brw-r--r-- 1 root root 8, 0 Aug 14 2006 sda
brw-r--r-- 1 root root 8, 1 Aug 14 2006 sda1
brw-r--r-- 1 root root 8, 2 Aug 14 2006 sda2
brw-r--r-- 1 root root 8, 16 Aug 14 2006 sdb
brw-r--r-- 1 root root 8, 32 Aug 14 2006 sdc
crw-r--r-- 1 root root 21, 0 Aug 14 2006 sg0
crw-r--r-- 1 root root 21, 1 Aug 14 2006 sg1
crw-r--r-- 1 root root 21, 3 Jan 1 00:01 sg3
crw-r--r-- 1 root root 204, 64 May 11 2006 ttyAMA0
crw-r--r-- 1 root root 204, 65 May 11 2006 ttyAMA1
I mounted usbfs and able to see mass storage in /proc/bus/usb/devices
However when I try to mount by
Mount -t vfat /dev/sda /mnt/pendrive then
I get error "Mounting /dev/sda on /mems failed: No such device" I tried it on sdb and sdc as well but it's not mounted.
I also tried to run fdisk /dev/sda but same type of error appears.
Can any one tell me abt possible problem?
Regards
Manish
Quoted 5 lines · Manish RATHI
However when I try to mount by
Mount -t vfat/dev/sda/mnt/pendrivethen
I get error "Mounting/dev/sdaon /mems failed: No such device" I tried it on sdb and sdc as well but it's not mounted.I also tried to run fdisk
/dev/sdabut same type of error appears.
Try mounting using "/dev/sda1", rather than "/dev/sda".
The device "sda" is the *entire* disk, "sda1" is the first partition on it - this will contain your data.
Thanks,
Signature · 3 lines
Julian Calaby Email: [email protected]
Hi,
It doesn't work with /dev/sda1 or /dev/sda2, sda3, sdb, sdc1, sdb1
brw-r--r-- 1 root root 8, 0 Aug 14 2006 sda brw-r--r-- 1 root root 8, 1 Aug 14 2006 sda1 brw-r--r-- 1 root root 8, 2 Aug 14 2006 sda2 brw-r--r-- 1 root root 8, 16 Aug 14 2006 sdb brw-r--r-- 1 root root 8, 17 Aug 17 2006 sdb1 brw-r--r-- 1 root root 8, 18 Aug 17 2006 sdb2 brw-r--r-- 1 root root 8, 32 Aug 14 2006 sdc brw-r--r-- 1 root root 8, 33 Aug 17 2006 sdc1 brw-r--r-- 1 root root 8, 34 Aug 17 2006 sdc2 brw-r--r-- 1 root root 8, 35 Aug 17 2006 sdc3 brw-r--r-- 1 root root 8, 36 Aug 17 2006 sdc4 crw-r--r-- 1 root root 21, 0 Aug 14 2006 sg0 crw-r--r-- 1 root root 21, 3 Aug 14 2006 sg3
I am able to run fdisk and mkdosfs on /dev/sdb but again mount fail with "No such device"
Thanks
Regards
Manish
-----Original Message-----
From: Julian Calaby [mailto:[email protected]]
Sent: Friday, August 18, 2006 5:36 PM
To: Manish RATHI
Cc: [email protected]
Subject: Re: scsi problem with usb
Quoted 6 lines · Manish RATHI
However when I try to mount by
Mount -t vfat/dev/sda/mnt/pendrivethen
I get error "Mounting/dev/sdaon /mems failed: No such device" I tried it on sdb and sdc as well but it's not mounted.I also tried to run fdisk
/dev/sdabut same type of error appears.
Try mounting using "/dev/sda1", rather than "/dev/sda".
The device "sda" is the *entire* disk, "sda1" is the first partition on it - this will contain your data.
Thanks,
Signature · 3 lines
Julian Calaby Email: [email protected]
Quoted 3 lines · Manish RATHI
Hi,
It doesn't work with/dev/sda1or/dev/sda2, sda3, sdb, sdc1, sdb1
[snip]
Quoted 3 lines
I am able to run fdisk and mkdosfs on
/dev/sdbbut again mount fail with "No such device"
Well, sorry I couldn't help more - this is now outside of my experience.
Thanks,
Signature · 3 lines
Julian Calaby Email: [email protected]