Best way to add custom step
Hi All,
I need to add a custom step to my build process after the linux image is built into the binaries directory. I was wondering about what was the best way to go about this.
I could add my changes to the top level makefile or to the target\linux\Makefile.in file. Is one way better than the other? Is there a better way of doing this?
Thanks,
Will
Signature · 5 lines
------------------------------------------------------------------------ Will Wagner will_wagner at carallon.com Senior Project Engineer Office Tel: +44 (0)20 7371 2032 Carallon Ltd, Studio G20, Shepherds Building, Rockley Rd, London W14 0DA ------------------------------------------------------------------------
----- Original Message -----
From: "Will Wagner" <[email protected]>
To: <[email protected]>
Sent: Monday, February 11, 2008 4:13 PM
Subject: [Buildroot] Best way to add custom step
Quoted 6 lines
Hi All,
I need to add a custom step to my build process after the linux image is built into the binaries directory. I was wondering about what was the best way to go about this.
Quoted 6 lines
I could add my changes to the top level makefile or to the target\linux\Makefile.in file. Is one way better than the other? Is there a better way of doing this?
Thanks,
If it is board specific, then it makes more sense to put it in target/device and let the target depend on the linux binary.
What is the custom step?
Best Regards
Ulf Samuelsson
Quoted 8 lines
Quoted 8 lines
I need to add a custom step to my build process after the linux image is built into the binaries directory. I was wondering about what was the best way to go about this.
I could add my changes to the top level makefile or to the target\linux\Makefile.in file. Is one way better than the other? Is there a better way of doing this?
Quoted 6 lines
Quoted 2 lines
Thanks,
If it is board specific, then it makes more sense to put it in target/device and let the target depend on the linux binary.
Thanks, after looking at it some more I realised this.
Quoted 2 lines
What is the custom step?
Need to wrap the kernel image with some extra bytes that include crc and size so that nandboot accepts it.
Quoted 5 lines
Best Regards
Ulf Samuelsson
Signature · 5 lines
------------------------------------------------------------------------ Will Wagner will_wagner at carallon.com Senior Project Engineer Office Tel: +44 (0)20 7371 2032 Carallon Ltd, Studio G20, Shepherds Building, Rockley Rd, London W14 0DA ------------------------------------------------------------------------
Quoted 15 lines
Quoted 8 lines
Quoted 8 lines
I need to add a custom step to my build process after the linux image is built into the binaries directory. I was wondering about what was the best way to go about this.
I could add my changes to the top level makefile or to the target\linux\Makefile.in file. Is one way better than the other? Is there a better way of doing this?
Quoted 6 lines
Quoted 2 lines
Thanks,
If it is board specific, then it makes more sense to put it in target/device and let the target depend on the linux binary.
Quoted 9 lines
Thanks, after looking at it some more I realised this.
Quoted 2 lines
What is the custom step?
Need to wrap the kernel image with some extra bytes that include crc and size so that nandboot accepts it.
Quoted 1 line
Any plans to build NAND boot within Buildroot?
What is NAND boot?
Best Regards
Ulf Samuelsson