Missing natsemi PCI ID
Taken from "lspci -vvv".
The computer is an HP Pavilion ze4145 notebook. Most of the devices do not have corresponding PCI ID's in the kernel, but I am only worried about the NIC right now.
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Subsystem: Unknown device 3c08:2400
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
Quoted 1 line
TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at 8c00
Region 1: Memory at e0003000 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mAPME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Any help would be greatly appreciated, I've had this notebook for 6 months and cannot use the network card under Linux. I tested it with Windows and OpenBSD and the network card works fine under both.
--
Bubba Parker
[email protected]
Quoted 3 lines · On Tue, Aug 26, 2003 at 03:29:33PM -0500, Ro0tSiEgE LKML wrote:
The computer is an HP Pavilion ze4145 notebook. Most of the devices do not have corresponding PCI ID's in the kernel, but I am only worried about the NIC right now.
What's wrong with the NIC?
Quoted 1 line
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815
if you load the natsemi driver, what do you get?
Signature · 3 lines
Notice that as computers are becoming easier and easier to use, suddenly there's a big market for "Dummies" books. Cause and effect, or merely an ironic juxtaposition of unrelated facts?
Quoted 22 lines · On Tuesday 26 August 2003 22.29, Ro0tSiEgE LKML wrote:
Taken from "lspci -vvv".
The computer is an HP Pavilion ze4145 notebook. Most of the devices do not have corresponding PCI ID's in the kernel, but I am only worried about the NIC right now.00:12.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Subsystem: Unknown device 3c08:2400
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=mediumQuoted 1 line
TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at 8c00
Region 1: Memory ate0003000(32-bit, non-prefetchable)
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mAPME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Quoted 3 lines
Any help would be greatly appreciated, I've had this notebook for 6 months and cannot use the network card under Linux. I tested it with Windows and OpenBSD and the network card works fine under both.
Have you tried "# modprobe natsemi" ?
Followed by usual network configuration.
What distribution do you use?
/RogerL
Signature · 3 lines
Roger Larsson Skellefteå Sweden