mmc: dw_mmc: Set timeout to max upon resume
Subsystems (2)
PATCH 4/22 mmc: dw_mmc: Set timeout to max upon resume
From: Doug Anderson <[email protected]>
The TMOUT register is set to 0xffffffff at probe time but isn't set after suspend/resume. Add an init of this value.
No problems were observed without this (it will also be set in __dw_mci_start_request if there is data to send), but it makes the register dump before and after suspend cleaner.
Signed-off-by Doug Anderson <[email protected]>
Acked-by Seungwon Jeon <[email protected]>
Reviewed-by Tomasz Figa <[email protected]>
--- drivers/mmc/host/dw_mmc.c | 3 +++ 1 files changed, 3 insertions(+), 0 deletions(-)
drivers/mmc/host/dw_mmc.c +3 -0
@@ -2510,6 +2510,9 @@ int dw_mci_resume(struct dw_mci *host)/* Restore the old value at FIFOTH register */ mci_writel (host,FIFOTH , host->fifoth_val); +/* Put in max timeout */ +mci_writel (host,TMOUT ,0xFFFFFFFF ); +mci_writel (host,RINTSTS ,0xFFFFFFFF ); mci_writel(host, INTMASK, SDMMC_INT_CMD_DONE | SDMMC_INT_DATA_OVER | SDMMC_INT_TXDR | SDMMC_INT_RXDR |
Signature · 1 line
1.7.0.4