CONFIG_TOSHIBA Configure.help for 2.4.0-test11

@@ -13420,6 +13420,17 @@
   module, say M here and read Documentation/modules.txt. Most people
   will say N.
 
+Toshiba Laptop support
+CONFIG_TOSHIBA
+  If you intend to run this kernel on a Toshiba portable say yes
+  here. This adds a driver to safely access the System Management
+  Mode of the CPU on Toshiba portables. The System Management Mode
+  is used to set the BIOS and power saving options on Toshiba portables.
+
+  For information on utilities to make use of this driver see the
+  Toshiba Linux utilities website at:
+  http://www.buzzard.org.uk/toshiba/
+
 /dev/cpu/microcode - Intel P6 CPU microcode support
 CONFIG_MICROCODE
   If you say Y here and also to "/dev file system support" in the

@@ -268,6 +268,11 @@
   Most normal users won't need the RAM disk functionality, and can
   thus say N here.
 
+Default RAM disk size
+CONFIG_BLK_DEV_RAM_SIZE
+  The default value is 4096. Only change this if you know what are
+  you doing. If you are using IBM S/390, then set this to 8192.
+
 Initial RAM disk (initrd) support
 CONFIG_BLK_DEV_INITRD
   The initial RAM disk is a RAM disk that is loaded by the boot loader

@@ -14209,6 +14209,11 @@
   driver as a module you have to specify the MPU I/O base address with
   the parameter 'mpu_base=0xNNN'.
 
+C-Media PCI (CMI8338/8378)
+CONFIG_SOUND_CMPCI
+  Say Y or M if you have a PCI sound card using the CMI8338
+  or the CMI8378 chip.set.
+
 Creative EMU10K1 based PCI sound cards
 CONFIG_SOUND_EMU10K1
   Say Y or M if you have a PCI sound card using the EMU10K1

@@ -57,7 +57,7 @@
 ------------------------------------------
 Stefan Laudat <[email protected]>
 
-[Note: The CMI 8338 is unrelated and right now unsupported]
+[Note: The CMI 8338 is unrelated and is supported by cmpcpi.o]
 
 	
 	In order to use CMI8330 under Linux  you just have to use a proper isapnp.conf, a good isapnp and a little bit of patience.  I use isapnp 1.17, but