Skip to contentSkip to conversation

Sparc64 Compiles OK, but won't boot new kernel

DISCUSSION Norm Dressler 3 participants 4 messages Nov 23, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

I have been able to successfully compile the 2.4.14 and 2.4.15 kernels for Sparc64 but each gives me an error on boot-up:

Image to large for Destination (twice)

It then kicks me back to the silo prompt. My kernel is trimmed back quite a bit and there isn't a lot there.

It's not a compressed kernel -- should it be? How do I do that since the bzImage make is missing from the Sparc64 makefiles?

I am using Redhat 6.2 on an Enterprise 4000, 4 Ultrasparc-II CPU's and 2Gb of Ram.

Any suggestions??

Norm

#1 lore raw

You did not enable LVM support, did you?
if you did enable, with 2.4.15, yyopu will see the bug i wrote about.

I had similar problems like you, I simply compiled as a module all I could, and I solved.

Quoted 26 lines · Norm Dressler

Hi,

I have been able to successfully compile the 2.4.14 and 2.4.15 kernels for Sparc64 but each gives me an error on boot-up:

Image to large for Destination (twice)

It then kicks me back to the silo prompt. My kernel is trimmed back quite a bit and there isn't a lot there.

It's not a compressed kernel -- should it be? How do I do that since the bzImage make is missing from the Sparc64 makefiles?

I am using Redhat 6.2 on an Enterprise 4000, 4 Ultrasparc-II CPU's and 2Gb of Ram.

Any suggestions??

Norm

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

#3 lore raw
In reply to Norm Dressler

I was able to solve it -- I also had freeswan patched into the kernel and when you include the debug portions, it more then doubles the size of your kernel.

Norm

----- Original Message -----
From: "David S. Miller" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: November 23, 2001 3:25 PM
Subject: Re: Sparc64 Compiles OK, but won't boot new kernel

Quoted 5 lines

Compile more things as modules, your kernel has too many things compiled statically into it and is therefore too large to boot.