Skip to contentSkip to conversation

Routing Question

LARTC Christian Benvenuti 2 participants 2 messages Apr 6, 2007 – Apr 9, 2007

lore
Share & tools
lore
#0 lore raw

Hi Fernando,

Quoted 7 lines

Hi, Somebody can help me , i have a linux gateway running ipsec, so if i ping a host on a remote ipsec network from gateway packet goes out with external ip address of gateway , is there a way that packets going from gateway to a remote network be sourced from internal gateway ip ?

Thanks in advance
Fernando

I do not know what your setup and exact needs are, but have you tried the "src" option of the "ip route" command?

Example:

ip route add dev eth1 192.168.1.0/24 src 10.0.1.1

                                     ^^^^^^^^^^^^

The routing code uses the primary IP address of the outgoing interface, unless you explicitly configure the preferred source address (as in the example above).

Regards
/Christian
[http://benve.info]

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc

#1 lore raw

Hi, my setup is :

192.168.80.0/24 ---- > ( eth1:192.168.80.254 ) Linux ipsec Router (ppp0/ipsec0) ----> [ internet ] <-----Sonicwall (192.168.1.1) <----- 192.168.1.0/24

When a pc in 192.168.80.0/24 pings anything on 192.168.1.0/24 it works When Linux Ipsec Router pings anything on 192.168.1.0/24 it doesnt works, ping packet goes trough default route because packet originates on eth1

some time ago i made a script using a 2nd route table but i cant find it or remember

----- Original Message -----
From: "Christian Benvenuti" <[email protected]>
To: <[email protected]>
Sent: Friday, April 06, 2007 7:29 PM
Subject: [LARTC] Re: Routing Question

Quoted 27 lines

Hi Fernando,

Quoted 7 lines

Hi, Somebody can help me , i have a linux gateway running ipsec, so if i ping a host on a remote ipsec network from gateway packet goes out with external ip address of gateway , is there a way that packets going from gateway to a remote network be sourced from internal gateway ip ?

Thanks in advance
Fernando

I do not know what your setup and exact needs are, but have you tried the "src" option of the "ip route" command?

Example:

ip route add dev eth1 192.168.1.0/24 src 10.0.1.1

                                    ^^^^^^^^^^^^

The routing code uses the primary IP address of the outgoing interface, unless you explicitly configure the preferred source address (as in the example above).

Regards
/Christian
[http://benve.info]

Quoted 4 lines

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc