Skip to contentSkip to conversation

mmcqd cpu utilization

DISCUSSION Madhusudhan 3 participants 4 messages Sep 2, 2009 MMC, SD and SDIO

lore
Share & tools
lore
#0 lore raw

Hi,

Has anyone monitored the cpu utilization percentage when a MMC/SD card is in use? I have noticed that mmc_queue_thread "mmcqd" consumes a lot of cpu cycles in a periodic fashion. What I mean here is that I see spikes of high cpu utilization due to mmcqd. There will a cp or similar which will be already consuming cpu to transfer data to the MMC/SD device. Further mmcqd increases that load randomly to a high number.

Has anyone seen similar behavior? Any thoughts?

Regards,
Madhu

#1 lore raw
Quoted 11 lines · On Wed, 2 Sep 2009 12:23:59 -0500 "Madhusudhan" <[email protected]> wrote:

Hi,

Has anyone monitored the cpu utilization percentage when a MMC/SD card is in use? I have noticed that mmc_queue_thread "mmcqd" consumes a lot of cpu cycles in a periodic fashion. What I mean here is that I see spikes of high cpu utilization due to mmcqd. There will a cp or similar which will be already consuming cpu to transfer data to the MMC/SD device. Further mmcqd increases that load randomly to a high number.

Has anyone seen similar behavior? Any thoughts?

My guess would be that the omap driver doesn't (cannot?) use the hardware to wait for busy to end, so the system must poll.

Anything better than that guess will require some profiling. :)

Rgds

Signature · 6 lines
     -- Pierre Ossman

  WARNING: This correspondence is being monitored by the
  Swedish government. Make sure your server uses encryption
  for SMTP traffic and consider using PGP for end-to-end
  encryption.
#2 lore raw
Quoted 21 lines

-----Original Message-----
From: Pierre Ossman [mailto:[email protected]]
Sent: Wednesday, September 02, 2009 12:41 PM
To: Madhusudhan
Cc: [email protected]; [email protected]; [email protected]
Subject: Re: mmcqd cpu utilization

Quoted 3 lines · On Wed, 2 Sep 2009 12:23:59 -0500 "Madhusudhan" <[email protected]> wrote:

Hi,

Has anyone monitored the cpu utilization percentage when a MMC/SD card

is in

Quoted 2 lines

use? I have noticed that mmc_queue_thread "mmcqd" consumes a lot of cpu cycles in a periodic fashion. What I mean here is that I see spikes of

high

Quoted 2 lines

cpu utilization due to mmcqd. There will a cp or similar which will be already consuming cpu to transfer data to the MMC/SD device. Further

Quoted 9 lines

mmcqd

Quoted 4 lines

increases that load randomly to a high number.

Has anyone seen similar behavior? Any thoughts?

My guess would be that the omap driver doesn't (cannot?) use the hardware to wait for busy to end, so the system must poll.

So your guess hints probably at "wait_for_completion(&complete)". Am I correct?

Regards,
Madhu

Quoted 10 lines

Anything better than that guess will require some profiling. :)

Rgds
--
-- Pierre Ossman

WARNING: This correspondence is being monitored by the Swedish government. Make sure your server uses encryption for SMTP traffic and consider using PGP for end-to-end encryption.

#3 lore raw

Madhu,

Quoted 7 lines
Quoted 4 lines

My guess would be that the omap driver doesn't (cannot?) use the hardware to wait for busy to end, so the system must poll.

So your guess hints probably at "wait_for_completion(&complete)". Am I correct?

Madhu wait_for_completion is blocking call. Please check 'omap_mmc_request'