Skip to contentSkip to conversation

2.6.11-rc4 doubles CPU temperature

DISCUSSION Ben Castricum 2 participants 3 messages Feb 28, 2005 – Mar 3, 2005

lore
Share & tools
lore
#0 lore raw

For some weird reason, 2.6.11-rc4 up to the current BK tree about doubles my CPU temperature from 20 degrees Celcius to 40 while everything else is unchanged (load/processes/config). The system does seem a bit more sluggish, but that may just be a feeling. A cat /proc/cpu gives me

processor : 0
vendor_id : GenuineIntel
cpu family : 6
model : 6
model name : Celeron (Mendocino)
stepping : 5
cpu MHz : 475.100
cache size : 128 KB
fdiv_bug : no
hlt_bug : no
f00f_bug : no
coma_bug : no
fpu : yes
fpu_exception : yes
cpuid level : 2
wp : yes
flags : fpu vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca
cmov pat pse36 mmx fxsr
bogomips : 940.03

and my .config can be found at

http://www.bencastricum.nl/.config

I haven't got a clue on how to analyse this problem so I really appreciate any info or suggestions I get. Please help me.

Cheers,
Ben

#1 lore raw

Hi Ben,

Quoted 5 lines · Ben Castricum

For some weird reason, 2.6.11-rc4 up to the current BK tree about doubles my CPU temperature from 20 degrees Celcius to 40 while everything else is unchanged (load/processes/config). The system
does seem a bit more sluggish, but that may just be a feeling. (...)
I haven't got a clue on how to analyse this problem so I really appreciate
any info or suggestions I get. Please help me.

If you have an Asus AS99127F chip, the value reported before in sysfs were not correct, the new ones are.

http://archives.andrew.net.au/lm-sensors/msg29730.html

40 degrees C is a fairly reasonable temperature for a CPU diode, there's nothing to be afraid of. At any rate it's more reasonable than the incredibly low 20 degrees C temperature you had before, as Robert Hancock noticed in an earlier post.

Hope that helps,

Signature · 1 line
Jean Delvare
#2 lore raw

Hi Jean,

Quoted 1 line

If you have an Asus AS99127F chip, the value reported before in sysfs were not correct, the new ones are.

This is indeed the case. To be sure I ran unixbench on rc3 and the just released 2.6.11 en the results were nearly identical. So the temperature increase does not seems to indicate that the CPU is doing more.

Quoted 1 line

40 degrees C is a fairly reasonable temperature for a CPU diode, there's nothing to be afraid of. At any rate it's more reasonable than the incredibly low 20 degrees C temperature you had before, as Robert Hancock noticed in an earlier post.

Then I have proabably been measuring it wrong from start. I will upgrade lm_sensors and try again.

Thanks,
Ben