Source
I am trying to setup some rules that apply to a range of source ip address in a subnet. Example 10.1.1.60-65 I know that you can specify individual ip adress with -s but this would make me do allot of repeating because I will have to apply the same rules to each ip address. Any help would be appreciated. Thanks
Bobby Guerra
[email protected]
Quoted 5 lines · Bobby Guerra
I am trying to setup some rules that apply to a range of source ip address in a subnet. Example 10.1.1.60-65 I know that you can specify individual ip adress with -s but this would make me do allot of repeating because I will have to apply the same rules to each ip address. Any help would be appreciated. Thanks
I don't know if using netmasks would help?
Signature · 2 lines
Vincent Lim <[email protected]> NESTAC Solution Sdn Bhd
----- Original Message -----
From: "Vincent Lim" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: Friday, April 11, 2003 11:22 AM
Subject: Re: Source
Quoted 2 lines · Bobby Guerra
Quoted 1 line
I am trying to setup some rules that apply to a range of source ip
address
Quoted 1 line
Quoted 1 line
in a subnet. Example 10.1.1.60-65 I know that you can specify
individual
Quoted 6 lines
Quoted 3 lines
ip adress with -s but this would make me do allot of repeating because I will have to apply the same rules to each ip address. Any help would be appreciated. Thanks
I don't know if using netmasks would help?
You can factorise it down to two lines:
-s 10.1.1.60/30 which gets .60, .61, .62 and .63
-s 10.1.1.64/31 which gets .64 and .65better if you can organise the ip addresses of the hosts that you want to filter
so that they fit inside a single mask, for example number your six hosts 64-69
inclusive, then do not have a host .70 or .71 and you can use a single match:
-s 10.1.1.64/29 which gets .64 -> .71
that's what netmasks are for...
Mike