Adaptec AIC7xxx version 6.08BETA release
SuSE Linux 7.0, Kernel 2.4.0
Adaptec 3950U2
Adaptec 2940
Although the kernel is complaining about the following things:
kernel: scsi0: PCI error Interrupt at seqaddr= 0x4e
kernel: scsi0: Data Parity Error Detected during address or write data phase
...
This is compared to the original drivers already a incredible
change: Those freezed my system after some time (something that did not happen before I upgraded from a K6-2 to a K6-2+: Apparently the old driver is working with loops or something)
Continue like this!
Marcel
____________________________________________________________________
Marcel Weber
[email protected]
http://www.ncpro.com
Made and sent with Linux
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Quoted 13 lines · Marcel Weber
SuSE Linux 7.0, Kernel 2.4.0
Adaptec 3950U2
Adaptec 2940Although the kernel is complaining about the following things:
kernel: scsi0: PCI error Interrupt at seqaddr=
0x4e
kernel: scsi0: Data Parity Error Detected during address or write data phase
...
Quoted 5 lines
This is compared to the original drivers already a incredible
change: Those freezed my system after some time (something that did not happen before I upgraded from a K6-2 to a K6-2+: Apparently the old driver is working with loops or something)
Hmm.. I start wondering if this is what I see too..
Both 2.2.18 and 2.4.0 hangs for some reason that I have not been able to trace down - Saturday I tried to remove all PCI cards but my 3dfx and AIC7xxx
00:0f.0 SCSI storage controller: Adaptec AHA-7850 (rev 01)
Has some driver been ported between 2.2 and 2.4 series recently ? I have not seen this problem before...
I will try the new driver too...
/RogerL
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/