I want kerneld back..
Actually I discovered the problem just about an hour after my post. I looked *really* close at RedHat's rc.sysinit script which appeared to be setup properly for handling kmod versus kerneld. Basically what was broke was that it wasn't running depmod -a on startup if kmod was enabled though it would do everything else correctly. Since changing that worked I assume depmod should be run at startup.
Brian Macy
----- Original Message -----
From: Greg Zornetzer <[email protected]>
To: Brian Macy <[email protected]>
Cc: <[email protected]>
Sent: Saturday, January 30, 1999 1:31 PM
Subject: Re: I want kerneld back..
Quoted 5 lines
Hi Brian,
Quoted 1 line · Brian Macy
Actually I just want kmod to work. I've mentioned this since I started
using
Quoted 5 lines
Quoted 5 lines
2.1.12? but all I get is read the
FAQs/ChangeLog/kmod.txt. I have... it don't help.The best I've gotten kmod to do is *if* I build SCSI support as a module
and insmodscsi_modmanually in rc.local, It will load the tape, cdrom,
and
Quoted 33 lines
Quoted 7 lines
initio drivers automatically when accessed. I can't get it to work at all with eth0/eth1 and when I compiled SCSI support into the kernel the tape, cdrom, and initio drivers would no longer autoload.
Please help... I've been using modules (especially for ethernet and SCSI) for years without problems but the 2.1.1* through 2.2.1 kernels have just got me beat.
Do you have any error messages? What happens when you try to load the SCSI support. If no modules are loaded, you really should be seeing in the syslog something to the effect of "Module xxxx could not be loaded". While I don't have modular SCSI on any of my systems, I do have module support compiled for SCSI cdroms, and generic SCSI access, and these seem to work smoothly. I'm truly surprised that autoloading of ethernet modules fails - again, can we see some clips of the syslog? Also, can we see a copy of your
/etc/conf.modules(or modules.conf, which ever one you use). These will be helpful in tracking down your problems.Quoted 5 lines
I'm using modutils-2.1.121, kerneld is not running, echo "
/sbin/modprobe"
/proc/sys/kernel/modprobeis being done, kmod is built into the kernel, conf.modules doesn't need to change (at least from what I've read).Looks like you're up to date, WRT the packages.
Quoted 2 lines
Brian Macy
Greg Zornetzer - [email protected]
"Light shines brightest in the darkest night"
http://www.contrib.andrew.cmu.edu/~gaz
Quoted 5 lines
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/