2.6.9: serial_core: uart_open
Quoted 27 lines · karl malbrain
Quoted 16 lines
The
uart_opencode loops waiting for CD to be asserted (whenever CLOCAL is not set). The bottom of the loop contains the following code:
up(&state->sem);schedule();down(&state->sem);
if( signal_pending(current) )
break;When I issue an
open("/dev/ttyS1", O_RDWR)from a terminal session on the console, the system seems to come to a stop in this loop until the process is killed. I suspect that the scheduler is choosing this process to run again because of an elevated console priority of some sort.Quoted 5 lines
Is there a kernel mechanism to put a process to sleep until awakened by an event to replace this looping behaviour?
Thanks, karl malbrain, malbrain-at-yahoo-dot-com
In the first place, you should perform an
open(O_NDELAY), so the open returns immediately with anything that has potential "modem-control". Then you can set the device to blocking usingfcntl(F_GETFL),F_SETFL.
Quoted 5 lines
Also, the task that is waiting for the
open()is sleeping. That's whatschedule()does.Cheers,
Dick Johnson
I'm looking for the POSIX behaviour of delaying the open until CD is asserted by the modem. If schedule() doesn't select another process to run, no wonder the system is hung at this point, because the uart_open loop doesn't break until CD is asserted by the modem. This sounds like a serious bug.
karl_m