ATA/100 Promise Board
Any idea why DMA is sometimes on and sometimes not for a few cdrom drives I have hooked up to my promise controller?
Whether it is on or off, whenever I copy a CD from a (dma) cdrom whether it dma is on or off it slows my system down big time. Move the cursor around in X, and it lags, watch X-Chat, the characters you type in slowly appear 3-5 seconds after.
Hook the same drives up to the motherboard ide interfaces and there is no lag at all.
This has always been the case with my cdroms.
When I had my HD on the Promise, it did DMA etc just fine.
Is there a problem with the driver if a HD is not on there it doesn't do DMA correctly or something?
Quoted 3 lines · war
Any idea why DMA is sometimes on and sometimes not for a few cdrom drives I have hooked up to my promise controller?
Someone posted here recently about atapi devices should not be on the promise card.
Signature · 5 lines
Linux, the choice | Hi! I'm a .signature virus! Copy me into
of a GNU generation -o) | your ~/.signature to help me spread!
Kernel 2.4.10-ac10 /\ |
on a i586 _\_v |
| ----- Original Message -----
From: "Josh McKinney" <[email protected]>
To: <[email protected]>
Sent: Wednesday, October 10, 2001 2:28 PM
Subject: Re: ATA/100 Promise Board
Quoted 5 lines · war
Quoted 3 lines
Any idea why DMA is sometimes on and sometimes not for a few cdrom drives I have hooked up to my promise controller?
Someone posted here recently about atapi devices should not be on the
promise card.
Quoted 1 line
That was me, and it's still true. Heh. Always attach optical drives directly to the motherboard, if possible.
On a similar note, I asked Promise a while back about the max number of supported Ultra66/Ultra100/etc controllers that they support in a single system.. No answer. Has anyone ever tried to cram a machine full of these cards?
Quoted 7 lines · Wilson
That was me, and it's still true. Heh. Always attach optical drives directly to the motherboard, if possible.
On a similar note, I asked Promise a while back about the max number of supported Ultra66/Ultra100/etc controllers that they support in a single system.. No answer. Has anyone ever tried to cram a machine full of these cards?
I have three fasttrack 66's and one ultra100 in the same box... at present it's out of pci slots, so I won't be adding more... ;)
Quoted 8 lines
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Signature · 8 lines
-------------------------------------------------------------------------- Joel Jaeggli [email protected] Academic User Services [email protected] PGP Key Fingerprint: 1DE9 8FCA 51FB 4195 B42A 9C32 A30D 121E -------------------------------------------------------------------------- It is clear that the arm of criticism cannot replace the criticism of arms. Karl Marx -- Introduction to the critique of Hegel's Philosophy of the right, 1843.
----- Original Message -----
From: "Joel Jaeggli" <[email protected]>
To: "Wilson" <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, October 10, 2001 3:20 PM
Subject: Re: ATA/100 Promise Board
Quoted 4 lines
I have three fasttrack 66's and one ultra100 in the same box... at present it's out of pci slots, so I won't be adding more... ;)
Quoting from pdc202xx.c:
* The latest chipset code will support the following :: * Three Ultra33 controllers and 12 drives. * 8 are UDMA supported and 4 are limited to DMA mode 2 multi-word. * The 8/4 ratio is a BIOS code limit by promise.
*
* UNLESS you enable "CONFIG_PDC202XX_BURST"
Does this match your experiences with that many controllers in the same box? Thanks for the reply, by the way.
Quoted 17 lines · Wilson
----- Original Message -----
From: "Joel Jaeggli" <[email protected]>
To: "Wilson" <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, October 10, 2001 3:20 PM
Subject: Re: ATA/100 Promise BoardQuoted 4 lines
I have three fasttrack 66's and one ultra100 in the same box... at present it's out of pci slots, so I won't be adding more... ;)
Quoting from
pdc202xx.c:* The latest chipset code will support the following :: * Three Ultra33 controllers and 12 drives. * 8 are UDMA supported and 4 are limited to DMA mode 2 multi-word. * The 8/4 ratio is a BIOS code limit by promise.
Quoted 5 lines
*
* UNLESS you enable "CONFIG_PDC202XX_BURST"Does this match your experiences with that many controllers in the same box? Thanks for the reply, by the way.
I don't have any of the ultra33 (20246) controllers... but I do have CONFIG_PDC202XX_BURST set (ie. the "enabled special dma feature"). everything is more or less normal except that I think hdk in the box is slowly dying at this point... this box has 8 drives on four controllers rather than 12 on 3
hda: WDC AC22000L, ATA DISK drive
hdc: IBM-DTLA-307015, ATA DISK drive
hde: Maxtor 98196H8, ATA DISK drive
hdg: IBM-DTLA-307075, ATA DISK drive
hdi: WDC AC418000D, ATA DISK drive
hdk: WDC AC418000D, ATA DISK drive
hdm: WDC WD273BA, ATA DISK drive
hdo: WDC WD273BA, ATA DISK drive
Quoted 8 lines
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Signature · 8 lines
-------------------------------------------------------------------------- Joel Jaeggli [email protected] Academic User Services [email protected] PGP Key Fingerprint: 1DE9 8FCA 51FB 4195 B42A 9C32 A30D 121E -------------------------------------------------------------------------- It is clear that the arm of criticism cannot replace the criticism of arms. Karl Marx -- Introduction to the critique of Hegel's Philosophy of the right, 1843.
----- Original Message -----
From: "Joel Jaeggli" <[email protected]>
To: "Wilson" <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, October 10, 2001 3:49 PM
Subject: Re: ATA/100 Promise Board
Quoted 10 lines
Quoted 10 lines
Quoting from
pdc202xx.c:* The latest chipset code will support the following :: * Three Ultra33 controllers and 12 drives. * 8 are UDMA supported and 4 are limited to DMA mode 2 multi-word. * The 8/4 ratio is a BIOS code limit by promise.*
* UNLESS you enable "CONFIG_PDC202XX_BURST"Does this match your experiences with that many controllers in the same
box?
Quoted 8 lines
Quoted 1 line
Thanks for the reply, by the way.
I don't have any of the ultra33 (20246) controllers... but I do have
CONFIG_PDC202XX_BURSTset (ie. the "enabled special dma feature"). everything is more or less normal except that I think hdk in the box is slowly dying at this point... this box has 8 drives on four controllers rather than 12 on 3
Quoted 9 lines
hda: WDC AC22000L, ATA DISK drive
hdc: IBM-DTLA-307015, ATA DISK drive
hde: Maxtor 98196H8, ATA DISK drive
hdg: IBM-DTLA-307075, ATA DISK drive
hdi: WDC AC418000D, ATA DISK drive
hdk: WDC AC418000D, ATA DISK drive
hdm: WDC WD273BA, ATA DISK drive
hdo: WDC WD273BA, ATA DISK drive
Awesome. Thanks for the info. I'll feel relatively safe recommending this kind of thing to others in the future, then.
--Wilson.