Skip to contentSkip to conversation

2.6.10 TCP troubles

DISCUSSION Hubert Tonneau 4 participants 4 messages Jan 5, 2005

lore
Share & tools
lore
#0 lore raw
Quoted 11 lines · Francois Romieu

Hubert Tonneau <[email protected]> :

Quoted 6 lines

Here is the senario:
the Linux machine is writting through libsmbclient to an OSX machine running Samba

Switching the Linux machine from 2.6.8 to 2.6.10 made the network speed drop drastically: 20 seconds with 2.6.8, 800 seconds with 2.6.10

Are there any differences in:
- dmesg output

No.

Quoted 3 lines

- /proc/interrupts
- disk traffic
- tcpdump output (of course there will)

I cannot see anymore since it's our main production server, so I switched back at once. Sorry about that. Anyway, both network traffic and disk traffic was very low.

The problem is not related to the Linux machine beeing slow because the network exchange was very fast with other gigabit with flow control connected machines. The problem seems to me to be related to the way the TCP layer is handling small troubles (probably lost packets on the Mac side because the Linux machine is gigabit connected to the switch, with flow control enabled, and the Mac is 100 Mbps connected, full duplex, but without flow control).

Please notice that the Linux machine is the client, and is pushing files to the Mac, which is quite unusual. If the Mac was the client pulling files from the PC, I bet things might be very different.

#1 lore raw
Quoted 3 lines · Hubert Tonneau

troubles (probably lost packets on the Mac side because the Linux machine is gigabit connected to the switch, with flow control enabled, and the Mac is 100 Mbps connected, full duplex, but without flow control).

Through a firewall ?

#2 lore raw
In reply to Hubert Tonneau

On Wed, Jan 05, 2005 at 12:50:57PM +0000, Hubert Tonneau wrote:
[quote reformatted to fit within 80 columns]

Quoted 5 lines

The problem seems to me to be related to the way the TCP layer is handling small troubles (probably lost packets on the Mac side because the Linux machine is gigabit connected to the switch, with flow control enabled, and the Mac is 100 Mbps connected, full duplex, but without flow control).

What OS is the Mac running? If it's Mac OS, then is it Mac OS X or is it an earlier version?

-Barry K. Nathan <[email protected]>

#3 lore raw
In reply to Hubert Tonneau

Hubert Tonneau <[email protected]> :
[...]

Quoted 4 lines

The problem seems to me to be related to the way the TCP layer is handling small troubles (probably lost packets on the Mac side because the Linux machine is gigabit connected to the switch, with flow control enabled, and the Mac is 100 Mbps connected, full duplex, but without flow control).

tcpdump should enlighten it.

--
Ueimor