Skip to contentSkip to conversation

Uboot image size reduction

U-Boot-Users Vijayakumar 2 participants 2 messages Mar 6, 2006

lore
Share & tools
lore
#0 lore raw

Hi all,

I am trying to build a uboot image of size 90k.

My full image having all the functionality has a size of 169k. Till now i am able to reduce its size to 106k.

Things i did to reduce it to 106k are

-- disabled all the commands except (loadb,saveenv,setenv,help,printenv,protect) which are not used to load the kernel image.
-- disabled the longhelp macro.

Is there any possibility to compress some parts of uboot and decompress into the memory when needed?

Also i am open to any suggestions which can help me to redue the image size close to 90k

Thanks in advance.
Vijayakumar

#1 lore raw
Quoted 2 lines · In message <081d01c640e8$31405d90$e001a8c0@Vijayakumar> you wrote:

I am trying to build a uboot image of size 90k.

90 k is a funny size. It does not match typical flash sector sizes. How did you come to such a size restriction?

Quoted 2 lines

Is there any possibility to compress some parts of uboot and decompress into the memory when needed?

No. if you think about the code needed to do that you will soon see that this does not fit into U-Boot's design principles (easily portable, provide success [and error!] messages as early as possible, etc.).

Quoted 2 lines

Also i am open to any suggestions which can help me to redue the image size close to 90k

Use latest compilers, i. e. GCC 4.x; they optimize much better than older versions.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Substitute "damn" every time you're inclined to write "very"; your
editor will delete it and the writing will be just as it should be.
                - Mark Twain