Skip to contentSkip to conversation

Using Parallel Port to Receive Signals

DISCUSSION [email protected] 2 participants 2 messages May 19, 2001

lore
Share & tools
lore
#0 lore raw

I am trying to use the data port of parallel port to receive data, so I set the bit 5 of the control port to enable the bi-directional port, but it doesn't work. My parallel supports SPP/EPP/ECP mode, does it support bi-directional mode? if yes, how can I config it?

I wish to be personally CC'ed the answers/comments posted to the list in response to my posting. Thank you.

Best Regards,
Anton
----------------------------------------------
�w��ϥ�HongKong.com�l��t��
Thank you for using hongkong.com Email system

#1 lore raw
Quoted 4 lines

I am trying to use the data port of parallel port to receive data, so I= set the bit 5 of the control port to enable the bi-directional port, b= ut it doesn't work. My parallel supports SPP/EPP/ECP mode, does it sup= port bi-directional mode? if yes, how can I config it?

You might have to play with your BIOS settings. What mode does it think the port is in?

p.