: 2.4.18-rc1 - Unable to mount CD-ROM/RW
A message that is not in the archive (sent off-list or not yet received): LI5YSPXWYTY04431V32LFIF97042TP.3c7534b4@jss
It's an LFS distribution i built. The problem is 2.4.17 didn't have this problem. Something introduced into 2.4.18-pre/rc.
I compile my core devices into kernel.
Shawn.
Quoted 65 lines · J.S.Souza
What distro are you using? If you are using RedHat 7.2 then there are known issues with the installer. Some of the fixes suggest doing a 'depmod -ae' (this
is redhat's fix on their website - I forget the exact URL btw). Anyways, try 'depmod -ae' and see if that fixes it.Quoted 56 lines · Shawn Starr
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX3: IDE controller on PCI bus 00 dev 39
PIIX3: chipset revision 0
PIIX3: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:pio, hdd:pio
hda: FUJITSU MPE3064AT, ATA DISK drive
hdb: WDC AC32500H, ATA DISK drive
hdc: YAMAHA CRW2100E, ATAPI CD/DVD-ROM drive <--------------------
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 12672450 sectors (6488 MB) w/512KiB Cache, CHS=788/255/63, (U)DMA
hdb: Disabling (U)DMA for WDC AC32500H
hdb: 4999680 sectors (2560 MB) w/128KiB Cache, CHS=620/128/63 Partition check:
hda: hda1 hda2
hdb: hdb1
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 00:0c.0: 3Com PCI 3c900 Cyclone 10Mbps TPO at0xe880. Vers LK1.1.16 PPP generic driver version 2.4.1
PPP Deflate Compression module registered
PPP BSD Compression module registered
SCSI subsystem driver Revision: 1.00
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4<Adaptec 2902/04/10/15/20/30C SCSI adapter> aic7850: Single Channel A, SCSI Id=7, 3/253 SCBsVendor: HP Model: T4000s Rev: 1.10
Type: Sequential-Access ANSI SCSI revision: 02
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: YAMAHA Model: CRW2100E Rev: 1.0N <----------------
Type: CD-ROM ANSI SCSI revision: 02
st: Version 20020205, bufsize 32768, wrt 30720, max init. bufs 4, s/g segs 16
Attached scsi tape st0 at scsi0, channel 0, id 4, lun 0When i attempt to mount
/dev/cdrom(symlink to/dev/scd0) I getmount:
/dev/cdromis not a valid block device (or/dev/scd0).What broke? :-(
Shawn.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Quoted 2 lines · Shawn Starr
It's an LFS distribution i built. The problem is 2.4.17 didn't have this problem. Something introduced into 2.4.18-pre/rc.
Hmm, when I spoke with you this morning on #kn I forgot to mention I'm using rc2-ac1, which as someone else mentioned, doesn't exhibit the symptoms you describe. Were the sg changes/updates ever applied to 2.4 mainline? I know they went into Alan's tree in .12 or .13 ...
Signature · 2 lines
Dan Chen [email protected] GPG key: www.unc.edu/~crimsun/pubkey.gpg.asc
Interesting, I will find out when i push out -shawn7 tonght (Quota problems will remain still).
Shawn.
Quoted 12 lines · Dan Chen
Quoted 2 lines · Shawn Starr
It's an LFS distribution i built. The problem is 2.4.17 didn't have this problem. Something introduced into 2.4.18-pre/rc.
Hmm, when I spoke with you this morning on #kn I forgot to mention I'm using rc2-ac1, which as someone else mentioned, doesn't exhibit the symptoms you describe. Were the sg changes/updates ever applied to 2.4 mainline? I know they went into Alan's tree in .12 or .13 ...
Signature · 2 lines
Dan Chen [email protected] GPG key: www.unc.edu/~crimsun/pubkey.gpg.asc