Skip to contentSkip to conversation

2.5: mark variables as __initdata

PATCH New Robert Love 1 participant 1 message Jun 19, 2002

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 2.5: mark variables as __initdata

The attached patch marks the following variables with __initdata:

arch/i386/kernel/mpparse.c :: static unsigned int num_processors arch/i386/kernel/smpboot.c :: static int smp_b_stepping arch/i386/kernel/smpboot.c :: static int max_cpus

The data is static and only used by __init functions so can successfully be jettisoned after boot. Compiled and booted successfully on an SMP machine.

I also set max_cpus to NR_CPUS instead of -1. Besides being the logically correct value and simplifying a loop elsewhere, this change allows NR_CPUS to be set to various values other than the normal 32 which is growing in utility with the hotplug CPU changes now in mainline.

Patch is against 2.5.23.

Robert Love

arch/i386/kernel/mpparse.c +1 -1
diff -urN linux-2.5.23/arch/i386/kernel/mpparse.c linux/arch/i386/kernel/mpparse.c
@@ -64,7 +64,7 @@
 unsigned int boot_cpu_physical_apicid = -1U;
 unsigned int boot_cpu_logical_apicid = -1U;
 /* Internal processor count */
-static unsigned int num_processors;
+static unsigned int __initdata num_processors;
 
 /* Bitmask of physically existing CPUs */
 unsigned long phys_cpu_present_map;
arch/i386/kernel/smpboot.c +4 -4
diff -urN linux-2.5.23/arch/i386/kernel/smpboot.c linux/arch/i386/kernel/smpboot.c
@@ -50,11 +50,11 @@
 #include <asm/tlbflush.h>
 #include <asm/smpboot.h>
 
-/* Set if we find a B stepping CPU			*/
-static int smp_b_stepping;
+/* Set if we find a B stepping CPU */
+static int __initdata smp_b_stepping;
 
 /* Setup configured maximum number of CPUs to activate */
-static int max_cpus = -1;
+static int __initdata max_cpus = NR_CPUS;
 
 /* Number of siblings per CPU package */
 int smp_num_siblings = 1;
@@ -1146,7 +1146,7 @@
 
 		if (!(phys_cpu_present_map & (1 << bit)))
 			continue;
-		if ((max_cpus >= 0) && (max_cpus <= cpucount+1))
+		if (max_cpus <= cpucount+1)
 			continue;
 
 		do_boot_cpu(apicid);