Skip to contentSkip to conversation

2.4.20 and 2.5.64 NIC missing interrupts in APIC mode

DISCUSSION Daniel Egger 2 participants 3 messages Mar 13, 2003 – Mar 14, 2003

lore
Share & tools
lore
#0 lore raw

Hija,

I just bought a new motherboard "ECS L7VTA" sporting a VIA KT400 chipset and found an annoying bug which took me quite some time to track down:

As soon as I enable the APIC mode in the BIOS the onboard PHY seems to ignore any packets which are thrown at it *after* the kernel initialised itself which is especially nasty since the system is booting from network effectively stopping its boot when trying to get an IP using DHCP or mounting a NFS volume in case the IP is fixed. The onboard NIC is a VIA Rhine II (VT6102).

The startup process looks like:
- POST
- BIOS check
- PXE BIOS initialisation
- PXE boot into etherboot
- Correct detection and initialisation of the NIC in etherboot
- Boot of linux kernel
- Correct initialisation of system including NIC (via-rhine driver from Donald Becker as in the standard kernels)
- Endless loop like the following:

-------->
eth0: Setting full-duplex based on MII #1 link partner capability of 41e1. Sending DCHP requests ...... timed out!
<--------

The NIC initialised itself with the correct interrupt according to the BIOS screen. As soon as I shut down the APIC mode, everything works as expected.

Ideas?

Signature · 2 lines
Servus,
       Daniel
#1 lore raw
Quoted 6 lines · Daniel Egger

As soon as I enable the APIC mode in the BIOS the onboard PHY seems to ignore any packets which are thrown at it *after* the kernel initialised itself which is especially nasty since the system is booting from network effectively stopping its boot when trying to get an IP using DHCP or mounting a NFS volume in case the IP is fixed. The onboard NIC is a VIA Rhine II (VT6102).

You may want to try 2.4.x-ac kernels, I believe Alan fixed some VIA APIC issues.

Roger

#2 lore raw

Am Don, 2003-03-13 um 21.24 schrieb Roger Luethi:

Quoted 9 lines
Quoted 6 lines

As soon as I enable the APIC mode in the BIOS the onboard PHY seems to ignore any packets which are thrown at it *after* the kernel initialised itself which is especially nasty since the system is booting from network effectively stopping its boot when trying to get an IP using DHCP or mounting a NFS volume in case the IP is fixed. The onboard NIC is a VIA Rhine II (VT6102).

You may want to try 2.4.x-ac kernels, I believe Alan fixed some VIA APIC issues.

According to Alans changelog the 2.5-ac has a forwardport of the VIA interrupt line patch, after some difficulties applying 2.5.64-ac3 to a rsynched post 2.5.64 kernel (some parts of the console changes didn't apply cleanly) I now tried it and it shows exactly the same symptoms.

Are there more VIA patches floating aroung? A short search on google didn't find anything particularly interesting.

Almost more annoying is that even after removing the fb support I cannot see enough of the messages to be helpful here, neither scrolllock nor shift-pgup help, probably also an interrupt issue though a bit seems to go through:
atkbd.c: Unknown key (set 2, scancode 0xb6, on isa0060/serio0) pressed.

Signature · 2 lines
Servus,
       Daniel