2.5.65 7880 SCSI bug
I have an Asus P2L97-DS motherboard. It has two PII-333 in it. I'm using the onboard SCSI interface, which is a 7880 (U). I have 5-SCSI drives (combination of wide and narrow), a SCSI CDROM and a SCSI tape drive. The drives have ID's 0-6 while the interface has ID 7.
When attempting to boot 2.5.65 or 2.5.64, neither is able to get past SCSI initialization. It simply loops and never completes a boot cycle. I have tried both the "newer" Adaptec AIC7xxx Fast -> U160 support (New Driver) and the older Adaptec AIC7xxx support (old driver). Both experience the same behavior.
I'm currently running 2.4.19 and this system has been working, more or less as is, since the mid 2.2-days.
Best Regards,
Greg Copeland
Quoted 5 lines · Greg Copeland
I have an Asus P2L97-DS motherboard. It has two PII-333 in it. I'm using the onboard SCSI interface, which is a 7880 (U). I have 5-SCSI drives (combination of wide and narrow), a SCSI CDROM and a SCSI tape drive. The drives have ID's 0-6 while the interface has ID 7.
Quoted 8 lines
When attempting to boot 2.5.65 or 2.5.64, neither is able to get past SCSI initialization. It simply loops and never completes a boot cycle. I have tried both the "newer" Adaptec AIC7xxx Fast -> U160 support (New Driver) and the older Adaptec AIC7xxx support (old driver). Both experience the same behavior.
I'm currently running 2.4.19 and this system has been working, more or less as is, since the mid 2.2-days.
Could you try booting with the following combinations of kernel parameters and report back.
1) "noapic"
2) "maxcpus=1"
3) "noirqbalance" with the appended patch.
Note that this didn't do anything for me either, my current workaround until i find out what's wrong is booting with noapic.
Index: linux-2.5.66/arch/i386/kernel/io_apic.c
===================================================================
RCS file: /build/cvsroot/linux-2.5.66/arch/i386/kernel/io_apic.c,v retrieving revision 1.1.1.1
arch/i386/kernel/io_apic.c +1 -1
@@ -1143,7 +1143,7 @@ void __init setup_IO_APIC_irqs(void) entry.delivery_mode =INT_DELIVERY_MODE ; entry.dest_mode =INT_DEST_MODE ; entry.mask =0 ;/* enable IRQ */ - entry.dest.logical.logical_dest =TARGET_CPUS ; + entry.dest.logical.logical_dest =1 ;/* TARGET_CPUS; */ idx =find_irq_entry (apic,pin,mp_INT);if (idx ==-1 ) {
Signature · 1 line
function.linuxpower.ca