Skip to contentSkip to conversation

aic7\x\x\x parity errors.

2.5.66-mm1 Ian Kumlien 1 participant 1 message Mar 30, 2003

lore
Share & tools
lore
#0 lore raw

Hi all,

I wanted to test 2.5 kernels, but i have to say that i have no clue about the current status of the drivers that use.

I checked dmesg to see what info it gave me and it just pushes loads of error messages as seen below.... The only thing i have on that scsi interface is two cdroms (one of which is a cd writer).

Is this known? Any information you guys want/need?

lspci:
00:0b.0 SCSI storage controller: Adaptec AHA-7850 (rev 03)

driver:
CONFIG_SCSI_AIC7XXX=y

driver options:
CONFIG_AIC7XXX_CMDS_PER_DEVICE=8 CONFIG_AIC7XXX_RESET_DELAY_MS=15000 CONFIG_AIC7XXX_DEBUG_ENABLE=y (shouldn't print all this data if it
wasn't important imho.)
CONFIG_AIC7XXX_DEBUG_MASK=0 CONFIG_AIC7XXX_REG_PRETTY_PRINT=y

dmesg is filled with:
scsi0: PCI error Interrupt at seqaddr = 0x7
scsi0: Data Parity Error Detected during address or write data phase
scsi0: PCI error Interrupt at seqaddr = 0x9
scsi0: Data Parity Error Detected during address or write data phase

CC since i don't think i could handle subscribing to this ml =)

Signature · 1 line
Ian Kumlien <[email protected]>