Skip to contentSkip to conversation

pcmcia hdsp problems

DISCUSSION jfm3 2 participants 2 messages May 8, 2003 – May 9, 2003 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

jfm3

author
#1 lore raw
Quoted 6 lines · Paul Davis

it didn't work because of the erroneous PCI ID that appeared for the h/w. the hammerfall-mem module counts how many Hammerfall-ish devices it can find, and allocates memory for them. a device claiming to be vendor 0xffff is not only illegal, its definitely not a hammerfall :)

--p

Thanks. I had gathered as much. Is there a way to tell snd-hammerfall-mem to allocate memory for a card even if it doesn't find one? I'd like to be able to put the pcmcia card in after the machine boots. The enable parameter to snd-hammerfall-mem doesn't seem to do anything anymore.

This is especially important to me right now because for some reason the pcmcia interface is not found correctly at boot time, only when the card is inserted after hotplug has started...

Signature · 8 lines
(jfm3  2838 BCBA 93BA 3058 ED95  A42C 37DB 66D1 B43C 9FD0)



-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara
The only event dedicated to issues related to Linux enterprise solutions
www.enterpriselinuxforum.com
#2 lore raw
Quoted 5 lines

Thanks. I had gathered as much. Is there a way to tell snd-hammerfall-mem to allocate memory for a card even if it doesn't find one? I'd like to be able to put the pcmcia card in after the machine boots. The enable parameter to snd-hammerfall-mem doesn't seem to do anything anymore.

no, it never did what you want right now. all it was therefore was to turn off memory allocation if the card was detected but for some reason you didn't want to use it.

the module would need a fairly significant overhaul to do what you're asking, although its actually a very small piece of code.

Quoted 3 lines

This is especially important to me right now because for some reason the pcmcia interface is not found correctly at boot time, only when the card is inserted after hotplug has started...

i think it might be better to see if you can find out why it comes up with an illegal PCI ID during boot time. that strikes me as very wrong (and almost certainly a BIOS/kernel issue, since i bet the same card in another machine would not do this).

--p

-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara The only event dedicated to issues related to Linux enterprise solutions www.enterpriselinuxforum.com