forcedeth
Quoted 5 lines · Markus
I tested this driver for my Nforce2 mobo on 2.6.0-test9, and this driver seemed useless, it just printed some random numbers in my konsole (And trust me, it was hard to edit lilo.conf so I even could boot back to old kernel when all the numbers just were jumping around)
The driver has full debugging enabled, and that includes hexdumping the start of every packet. This should disappear if you replace the "#if 1" with "#if 0", around line 80.
Quoted 4 lines
And it broke the
other card too, ifconfig was right, now there was this card too, but no one from them worked. Thanks anyway.
Which other card? I'm interested in more details, please explain.
So far I received two bug reports:
- smp locking is broken (stupid bug, I have a fix)
- sometimes a wrong mac address is used (unresolved)
--
Manfred
usually when I boot up it mount's the remote filesystems, now it just failed, and I tryed to ping lan/internet IP's they failed. And I noticed that none of my cards were working. this is the output of lspci for the card that works without forcedeth support in kernel and does not work if forcedeth is enabled:
01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
That's the main card that I use for lan/internet. ifconfig in the other hand told me that I had two working cards. first on had ip 192.168.0.2 (that's right) and the new card had 192.168.1.1.
su, 2003-11-09 kello 11:47, Manfred Spraul kirjoitti:
Quoted 9 lines
Quoted 4 lines
And it broke the
other card too, ifconfig was right, now there was this card too, but no one from them worked. Thanks anyway.Which other card? I'm interested in more details, please explain.
So far I received two bug reports:
- smp locking is broken (stupid bug, I have a fix)
- sometimes a wrong mac address is used (unresolved)
Regards,
Markus
Signature · 2 lines
"Software is like sex, it's better when it's free." Markus Hästbacka <midian at ihme.org>
Quoted 10 lines · Markus Hästbacka
usually when I boot up it mount's the remote filesystems, now it just failed, and I tryed to ping lan/internet IP's they failed. And I noticed that none of my cards were working. this is the output of lspci for the card that works without forcedeth support in kernel and does not work if forcedeth is enabled: 01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
That's the main card that I use for lan/internet. ifconfig in the other hand told me that I had two working cards. first on had ip 192.168.0.2 (that's right) and the new card had 192.168.1.1.
Please compare the mac addresses listed by ifconfig: I guess that the nics changed their names, the nforce chip is now eth0 and the realtek is eth1, or vice versa.
--
Manfred