Wolfson AC97 touch screen driver - wm97xx.h
PATCH 1/1 Wolfson AC97 touch screen driver - wm97xx.h
This patch moves the wm97xx.h header from include/linux to drivers/sound as the driver now uses the kernel input event interface.
Patch is against 2.4.24-pre1
Liam
drivers/sound/wm97xx.h +96 -0
@@ -0,0 +1,96 @@ + +/* +* Register bits for Wolfson WM97xx series of codecs +*/ + +#ifndef _WM97XX_H_ +#define _WM97XX_H_ + +#include <linux/ac97_codec.h> /* AC97 control layer */ + +/* +* WM97xx AC97 Touchscreen registers +*/ +#define AC97_WM97XX_DIGITISER1 0x76 +#define AC97_WM97XX_DIGITISER2 0x78 +#define AC97_WM97XX_DIGITISER_RD 0x7a + +/* +* WM97xx register bits +*/ +#define WM97XX_POLL 0x8000/* initiate a polling measurement */ +#define WM97XX_ADCSEL_X 0x1000/* x coord measurement */ +#define WM97XX_ADCSEL_Y 0x2000/* y coord measurement */ +#define WM97XX_ADCSEL_PRES 0x3000/* pressure measurement */ +#define WM97XX_COO 0x0800/* enable coordinate mode */ +#define WM97XX_CTC 0x0400/* enable continuous mode */ +#define WM97XX_CM_RATE_93 0x0000/* 93.75Hz continuous rate */ +#define WM97XX_CM_RATE_187 0x0100/* 187.5Hz continuous rate */ +#define WM97XX_CM_RATE_375 0x0200/* 375Hz continuous rate */ +#define WM97XX_CM_RATE_750 0x0300/* 750Hz continuous rate */ +#define WM97XX_CM_RATE_8K 0x00f0/* 8kHz continuous rate */ +#define WM97XX_CM_RATE_12K 0x01f0/* 12kHz continuous rate */ +#define WM97XX_CM_RATE_24K 0x02f0/* 24kHz continuous rate */ +#define WM97XX_CM_RATE_48K 0x03f0/* 48kHz continuous rate */ +#define WM97XX_DELAY (i) ((i << 4) & 0x00f0)/* sample delay times */ +#define WM97XX_SLEN 0x0008/* slot read back enable */ +#define WM97XX_SLT (i) ((i - 5) & 0x7)/* touchpanel slot selection (5-11) */ +#define WM97XX_PRP_DETW 0x4000/* pen detect on, digitiser off, wake up */ +#define WM97XX_PRP_DET 0x8000/* pen detect on, digitiser off, no wake up */ +#define WM97XX_PRP_DET_DIG 0xc000/* pen detect on, digitiser on */ +#define WM97XX_RPR 0x2000/* wake up on pen down */ +#define WM97XX_PEN_DOWN 0x8000/* pen is down */ + +/* WM9712 Bits */ +#define WM9712_45W 0x1000/* set for 5-wire touchscreen */ +#define WM9712_PDEN 0x0800/* measure only when pen down */ +#define WM9712_WAIT 0x0200/* wait until adc is read before next sample */ +#define WM9712_PIL 0x0100/* current used for pressure measurement. set 400uA else 200uA */ +#define WM9712_MASK_HI 0x0040/* hi on mask pin (47) stops conversions */ +#define WM9712_MASK_EDGE 0x0080/* rising/falling edge on pin delays sample */ +#define WM9712_MASK_SYNC 0x00c0/* rising/falling edge on mask initiates sample */ +#define WM9712_RPU (i) (i&0x3f)/* internal pull up on pen detect (64k / rpu) */ +#define WM9712_ADCSEL_COMP1 0x4000/* COMP1/AUX1 measurement (pin29) */ +#define WM9712_ADCSEL_COMP2 0x5000/* COMP2/AUX2 measurement (pin30) */ +#define WM9712_ADCSEL_BMON 0x6000/* BMON/AUX3 measurement (pin31) */ +#define WM9712_ADCSEL_WIPER 0x7000/* WIPER/AUX4 measurement (pin12) */ +#define WM9712_PD (i) (0x1 << i)/* power management */ + +/* WM9712 Registers */ +#define AC97_WM9712_POWER 0x24 +#define AC97_WM9712_REV 0x58 + +/* WM9705 Bits */ +#define WM9705_PDEN 0x1000/* measure only when pen is down */ +#define WM9705_PINV 0x0800/* inverts sense of pen down output */ +#define WM9705_BSEN 0x0400/* BUSY flag enable, pin47 is 1 when busy */ +#define WM9705_BINV 0x0200/* invert BUSY (pin47) output */ +#define WM9705_WAIT 0x0100/* wait until adc is read before next sample */ +#define WM9705_PIL 0x0080/* current used for pressure measurement. set 400uA else 200uA */ +#define WM9705_PHIZ 0x0040/* set PHONE and PCBEEP inputs to high impedance */ +#define WM9705_MASK_HI 0x0010/* hi on mask stops conversions */ +#define WM9705_MASK_EDGE 0x0020/* rising/falling edge on pin delays sample */ +#define WM9705_MASK_SYNC 0x0030/* rising/falling edge on mask initiates sample */ +#define WM9705_PDD (i) (i & 0x000f)/* pen detect comparator threshold */ +#define WM9705_ADCSEL_BMON 0x4000/* BMON measurement */ +#define WM9705_ADCSEL_AUX 0x5000/* AUX measurement */ +#define WM9705_ADCSEL_PHONE 0x6000/* PHONE measurement */ +#define WM9705_ADCSEL_PCBEEP 0x7000/* PCBEEP measurement */ + +/* AUX ADC ID's */ +#define TS_COMP1 0x0 +#define TS_COMP2 0x1 +#define TS_BMON 0x2 +#define TS_WIPER 0x3 + +/* ID numbers */ +#define WM97XX_ID1 0x574d +#define WM9712_ID2 0x4c12 +#define WM9705_ID2 0x4c05 + +#define AC97_LINK_FRAME 21/* time in uS for AC97 link frame */ + +void register_touchscreen_codec (struct ac97_codec *codec); +void unregister_touchscreen_codec (struct ac97_codec *codec); + +#endif
include/linux/wm97xx.h +0 -96
96 lines not on this page · raw message