Skip to contentSkip to conversation

No interrupts for PCMCIA cards

DISCUSSION Daniel Ritz 2 participants 2 messages Apr 4, 2004

lore
Share & tools
lore
#1 lore raw

Hi Daniel,

Quoted 6 lines

you can try my TI interrupt routing patch:
http://ritz.dnsalias.org/linux/pcmcia-ti-routing-9.patch
also included in 2.6.5-rc3-mm1 and higher:

	http://www.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.5-rc3/2.6.5-rc3-mm4/broken-out/yenta-TI-irq-routing-fix.patch

also the dmesg output with my patch applied would be nice to see...

thanks for the fast reply. This patch brings everything back in shape and here is the Yenta part from dmesg:

Linux Kernel Card Services
options: [pci] [cardbus] [pm]
PCI: Enabling device 0000:02:0e.0 (0000 -> 0002)
Yenta: CardBus bridge found at 0000:02:0e.0 [0000:0000]
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:02:0e.0, mfunc 0x00000000, devctl 0x66 Yenta TI: socket 0000:02:0e.0 probing PCI interrupt failed, trying to fix Yenta TI: socket 0000:02:0e.0 falling back to parallel PCI interrupts Yenta TI: socket 0000:02:0e.0 parallel PCI interrupts ok
Yenta: ISA IRQ mask 0x0000, PCI irq 18
Socket status: 30000047
NET: Registered protocol family 23
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0800-0x08ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x3c0-0x3df 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.

Regards

Marcel