2.6.9-rc2-mm4 e100 enable_irq unbalanced from
The e100 module is generating a warning:
Sep 27 13:30:29 deimos kernel: e100: Intel(R) PRO/100 Network Driver, 3.1.4-NAPI Sep 27 13:30:29 deimos kernel: e100: Copyright(c) 1999-2004 Intel Corporation Sep 27 13:30:29 deimos kernel: e100: eth0: e100_probe: addr 0xfecfc000, irq 16, MAC addr 00:90:27:3A:C5:E3 Sep 27 13:30:29 deimos kernel: enable_irq(16) unbalanced from ec83ff33 Sep 27 13:30:29 deimos kernel: [<c010923f>] enable_irq+0xcf/0xe0 Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100] Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100] Sep 27 13:30:29 deimos kernel: [<ec83f410>] e100_intr+0x0/0x140 [e100] Sep 27 13:30:29 deimos kernel: [<ec841131>] e100_open+0x31/0x80 [e100] Sep 27 13:30:29 deimos kernel: [<c0318d4c>] dev_open+0x8c/0xa0 Sep 27 13:30:29 deimos kernel: [<c031cc74>] dev_mc_upload+0x24/0x40 Sep 27 13:30:29 deimos kernel: [<c031a4ea>] dev_change_flags+0x12a/0x150 Sep 27 13:30:29 deimos kernel: [<c0318c0d>] dev_load+0x2d/0x80 Sep 27 13:30:29 deimos kernel: [<c0355b37>] devinet_ioctl+0x277/0x730
e100_up calls disable_irq, request_irq, then enable_irq as shown below.
static int e100_up(struct nic *nic)
{
...
disable_irq(nic->pdev->irq);
...
if((err = request_irq(nic->pdev->irq, e100_intr, SA_SHIRQ,
nic->netdev->name, nic->netdev)))
goto err_no_irq;
e100_enable_irq(nic);
enable_irq(nic->pdev->irq);
netif_wake_queue(nic->netdev);
return 0;
...
}On this machine, the e100 is the only device on that IRQ.
request_irq calls setup_irq which clears the irq descriptor depth member to 0 and enables the interrupt because this is the first device to use that interrupt.
This results in the warning on the next enable_irq().
I'm not sure why the driver is calling disable_irq IRQ before calling request_irq. You can't get that interrupt until you call request_irq, and once you call request_irq you can (at least when this is the first device on that IRQ) even before the call to enable_irq.
I suspect the correct thing is to remove disable_irq/enable_irq from e100_up.
I don't see any purpose for these calls in e100_up.
Signature · 2 lines
Paul Fulghum [email protected]
Quoted 8 lines · Paul Fulghum
The e100 module is generating a warning:
Sep 27 13:30:29 deimos kernel: e100: Intel(R) PRO/100 Network Driver, 3.1.4-NAPI Sep 27 13:30:29 deimos kernel: e100: Copyright(c) 1999-2004 Intel Corporation Sep 27 13:30:29 deimos kernel: e100: eth0: e100_probe: addr 0xfecfc000, irq 16, MAC addr 00:90:27:3A:C5:E3 Sep 27 13:30:29 deimos kernel: enable_irq(16) unbalanced from ec83ff33 Sep 27 13:30:29 deimos kernel: [<c010923f>] enable_irq+0xcf/0xe0 Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100]
The following patch works for me and removes the warning.
The disable_irq/enable_irq is not needed because the ISR can't be called before calling request_irq, the hardware is initialized before calling request_irq, and request_irq itself enables the interrupt if needed.
Comments?
Signature · 30 lines
Paul Fulghum [email protected] --- a/drivers/net/e100.c 2004-09-27 09:57:35.000000000 -0500 +++ b/drivers/net/e100.c 2004-09-27 16:00:12.115482112 -0500 @@ -1675,9 +1675,6 @@ if((err = e100_rx_alloc_list(nic))) return err; - - disable_irq(nic->pdev->irq); - if((err = e100_alloc_cbs(nic))) goto err_rx_clean_list; if((err = e100_hw_init(nic))) @@ -1689,7 +1686,6 @@ nic->netdev->name, nic->netdev))) goto err_no_irq; e100_enable_irq(nic); - enable_irq(nic->pdev->irq); netif_wake_queue(nic->netdev); return 0; @@ -1700,7 +1696,6 @@ err_rx_clean_list: e100_rx_clean_list(nic); - enable_irq(nic->pdev->irq); return err; }
Quoted 10 lines · Paul Fulghum
Quoted 8 lines · Paul Fulghum
The e100 module is generating a warning:
Sep 27 13:30:29 deimos kernel: e100: Intel(R) PRO/100 Network Driver, 3.1.4-NAPI Sep 27 13:30:29 deimos kernel: e100: Copyright(c) 1999-2004 Intel Corporation Sep 27 13:30:29 deimos kernel: e100: eth0: e100_probe: addr 0xfecfc000, irq 16, MAC addr 00:90:27:3A:C5:E3 Sep 27 13:30:29 deimos kernel: enable_irq(16) unbalanced from ec83ff33 Sep 27 13:30:29 deimos kernel: [<c010923f>] enable_irq+0xcf/0xe0 Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100]
Quoted 8 lines
The following patch works for me and removes the warning.
The disable_irq/enable_irq is not needed because the ISR can't be called before calling
request_irq, the hardware is initialized before callingrequest_irq, andrequest_irqitself enables the interrupt if needed.Comments?
Hi,
That change was my fault, to address a problem with doing a resume from suspend. The e100 in my laptop seems to emit a spurious interrupt on resume, and the intention was to block interrupts until the handler had been installed - otherwise I get a "got interrupt X and nobody cared" message.
While this works for me (probably because IRQ11 is heavily shared), it's apparently pretty bogus. But it did achieve the goal of getting the problem looked at...
J
Quoted 17 lines · Paul Fulghum
The e100 module is generating a warning:
Sep 27 13:30:29 deimos kernel: e100: Intel(R) PRO/100 Network Driver, 3.1.4-NAPI Sep 27 13:30:29 deimos kernel: e100: Copyright(c) 1999-2004 Intel Corporation Sep 27 13:30:29 deimos kernel: e100: eth0: e100_probe: addr 0xfecfc000, irq 16, MAC addr 00:90:27:3A:C5:E3 Sep 27 13:30:29 deimos kernel: enable_irq(16) unbalanced from ec83ff33 Sep 27 13:30:29 deimos kernel: [<c010923f>] enable_irq+0xcf/0xe0 Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100] Sep 27 13:30:29 deimos kernel: [<ec83ff33>] e100_up+0xf3/0x1f0 [e100] Sep 27 13:30:29 deimos kernel: [<ec83f410>] e100_intr+0x0/0x140 [e100] Sep 27 13:30:29 deimos kernel: [<ec841131>] e100_open+0x31/0x80 [e100] Sep 27 13:30:29 deimos kernel: [<c0318d4c>] dev_open+0x8c/0xa0 Sep 27 13:30:29 deimos kernel: [<c031cc74>] dev_mc_upload+0x24/0x40 Sep 27 13:30:29 deimos kernel: [<c031a4ea>] dev_change_flags+0x12a/0x150 Sep 27 13:30:29 deimos kernel: [<c0318c0d>] dev_load+0x2d/0x80 Sep 27 13:30:29 deimos kernel: [<c0355b37>] devinet_ioctl+0x277/0x730
Just a 'me-too', with a slightly different oops:
e100: Intel(R) PRO/100 Network Driver, 3.1.4-NAPI
e100: Copyright(c) 1999-2004 Intel Corporation
ACPI: PCI interrupt 0000:00:0d.0[A] -> GSI 19 (level, low) -> IRQ 185
e100: eth0: e100_probe: addr 0xf7161000, irq 185, MAC addr 00:30:48:41:22:9F enable_irq(185) unbalanced from f89b3e25
[<c0108973>] enable_irq+0xa3/0xf0 [<f89b3e25>] e100_up+0xd5/0x1e0 [e100] [<f89b3e25>] e100_up+0xd5/0x1e0 [e100] [<f89b4e9a>] e100_open+0x2a/0x90 [e100] [<c0368a24>] dev_open+0x74/0x90 [<c0369f66>] dev_change_flags+0x56/0x130 [<c03a2f42>] devinet_ioctl+0x5f2/0x6a0 [<c03a4e5f>] inet_ioctl+0xdf/0x100 [<c0360563>] sock_ioctl+0x1b3/0x270 [<c015a709>] fget+0x49/0x60 [<c016b905>] sys_ioctl+0x205/0x270 [<c0105b0d>] sysenter_past_esp+0x52/0x71
e100: eth0: e100_watchdog: link up, 100Mbps, full-duplex
--
J.A. Magallon <jamagallon()able!es> \ Software is like sex:
werewolf!able!es \ It's better when it's free
Mandrakelinux release 10.1 (Community) for i586
Linux 2.6.9-rc2-mm4 (gcc 3.4.1 (Mandrakelinux (Alpha 3.4.1-3mdk)) #2
Quoted 1 line · J.A. Magallon
Just a 'me-too', with a slightly different oops:
Can you try the following patch please?
Signature · 31 lines
Paul Fulghum [email protected] --- a/drivers/net/e100.c 2004-09-27 09:57:35.000000000 -0500 +++ b/drivers/net/e100.c 2004-09-27 16:00:12.115482112 -0500 @@ -1675,9 +1675,6 @@ if((err = e100_rx_alloc_list(nic))) return err; - - disable_irq(nic->pdev->irq); - if((err = e100_alloc_cbs(nic))) goto err_rx_clean_list; if((err = e100_hw_init(nic))) @@ -1689,7 +1686,6 @@ nic->netdev->name, nic->netdev))) goto err_no_irq; e100_enable_irq(nic); - enable_irq(nic->pdev->irq); netif_wake_queue(nic->netdev); return 0; @@ -1700,7 +1696,6 @@ err_rx_clean_list: e100_rx_clean_list(nic); - enable_irq(nic->pdev->irq); return err; }
Quoted 5 lines · Paul Fulghum
Quoted 1 line · J.A. Magallon
Just a 'me-too', with a slightly different oops:
Can you try the following patch please?
It has killed the messages, and I have not seen any side effects. Network is working fine.
--
J.A. Magallon <jamagallon()able!es> \ Software is like sex:
werewolf!able!es \ It's better when it's free
Mandrakelinux release 10.1 (Community) for i586
Linux 2.6.9-rc2-mm4 (gcc 3.4.1 (Mandrakelinux (Alpha 3.4.1-3mdk)) #2