Skip to contentSkip to conversation

G5 clock frequency scaling

DISCUSSION Arrigo Benedetti 2 participants 2 messages Nov 2, 2004 – Nov 3, 2004

lore
Share & tools
lore
#0 lore raw

Does anyone know if the current IBM 970 chips in dual G5 Powermacs and Xserves is under any clock frequency scaling control? In other words, is the clock freuquency always guardanteed to be the nominal, or it may change based on temperature? If this is the case, does the linux kernel have any control on it?

Thanks
-Arrigo

#1 lore raw
Quoted 6 lines · Arrigo Benedetti

Does anyone know if the current IBM 970 chips in dual G5 Powermacs and Xserves is under any clock frequency
scaling control? In other words, is the clock freuquency always guardanteed to be the nominal, or it may change
based on temperature? If this is the case, does the linux kernel have any control on it?

The current desktop models have a "clock slewing" capability which isn't used by the kernel at this point. So the machine stays at the speed it had when booting.

However, it's been observed that the firmware tend to boot at max speed when auto-booting, and at lowest speed (1.3Ghz generally observed) when entering the OF manual command line interface.

Ben.