2.6.9 slow
Hi!
I tested 2.6.9 with patched with host-skas3-2.6.9-v7.patch. It is very slow, but there is not a big load, nor a big disk io. (I checkd with iostat)
With 2.6.7 it is good.
bye
HyGy
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now.
http://productguide.itmanagersjournal.com/
_______________________________________________
User-mode-linux-devel mailing list [email protected]
https://lists.sourceforge.net/lists/listinfo/user-mode-linux-devel
Quoted 7 lines · Hegedus Gabor
Hi!
I tested 2.6.9 with patched with host-skas3-2.6.9-v7.patch. It is very slow, but there is not a big load, nor a big disk io. (I checkd with iostat)
With 2.6.7 it is good.
With SKAS or vanilla? I assume it's vanilla - might you try that with SKAS?
Quoted 2 lines
bye
HyGy
Well, basically SKAS is unlikely to cause that... I'd rather think that in your config 2.6.9 is slower than 2.6.7. Check if you've changed anything relevant on the kernel config.
To make sure that SKAS is not at fault:
- if it becomes slow after running some UMLs, then SKAS is probably at fault. Not otherwise.
- also, I guess that you'll have the performance hit even without SKAS patch applied. Make sure not to change the kernel configuration!
Signature · 14 lines
Paolo Giarrusso, aka Blaisorblade Linux registered user n. 292729 http://www.user-mode-linux.org/~blaisorblade ------------------------------------------------------- SF email is sponsored by - The IT Product Guide Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now. http://productguide.itmanagersjournal.com/ _______________________________________________ User-mode-linux-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/user-mode-linux-devel