Skip to contentSkip to conversation

Neighbour table overflow

DISCUSSION ro0ot 2 participants 2 messages Jan 5, 2005

lore
Share & tools
lore

ro0ot

author
#0 lore raw

Hi,

I had setup my bridge (br0) as below: -

ifconfig eth0 0.0.0.0
ifconfig eth5 0.0.0.0

brctl addbr br0

brctl addif br0 eth0
brctl addif br0 eth5

brctl stp br0 on

ifconfig br0 192.168.1.1 netmask 255.255.255.0 broadcast 192.168.1.255

I had my firewall scripts setup correctly.

Once I connect both the interface (eth0 and eth5) to my network. I can't ping to my router (connect to eth0) or ping to my other IP addresses (connect to eth5). I check around and found out some messages pops up in /var/log/syslog file as below: -

Jan  2 10:44:22 fw01 kernel: ipt_tcpmss_target: bad length (64 bytes)
Jan  2 10:44:32 fw01 last message repeated 11 times
Jan  2 12:27:08 fw01 kernel: Neighbour table overflow.
Jan  2 12:27:11 fw01 last message repeated 9 times
Jan  2 12:27:13 fw01 kernel: NET: 10 messages suppressed.
Jan  2 12:27:13 fw01 kernel: Neighbour table overflow.
Jan  2 12:27:18 fw01 kernel: NET: 27 messages suppressed.
Jan  2 12:27:18 fw01 kernel: Neighbour table overflow.

Once I disconnect the cable from the eth5 interface, I can ping to my router. I try to reconnect the cable back to the eth5 interface and run a ping to my router. As the result, I can't ping the router and the similar messages pops up in the /var/log/syslog file.

How can I resolve this issue?

Regards,
ro0ot

#1 lore raw
Quoted 32 lines · On Tue, 2005-01-04 at 19:42, ro0ot wrote:

Hi,

I had setup my bridge (br0) as below: -

ifconfig eth0 0.0.0.0
ifconfig eth5 0.0.0.0

brctl addbr br0

brctl addif br0 eth0
brctl addif br0 eth5

brctl stp br0 on

ifconfig br0 192.168.1.1 netmask 255.255.255.0 broadcast 192.168.1.255

I had my firewall scripts setup correctly.

Once I connect both the interface (eth0 and eth5) to my network. I can't ping to my router (connect to eth0) or ping to my other IP addresses (connect to eth5). I check around and found out some messages pops up in /var/log/syslog file as below: -

Jan  2 10:44:22 fw01 kernel: ipt_tcpmss_target: bad length (64 bytes)
Jan  2 10:44:32 fw01 last message repeated 11 times
Jan  2 12:27:08 fw01 kernel: Neighbour table overflow.
Jan  2 12:27:11 fw01 last message repeated 9 times
Jan  2 12:27:13 fw01 kernel: NET: 10 messages suppressed.
Jan  2 12:27:13 fw01 kernel: Neighbour table overflow.
Jan  2 12:27:18 fw01 kernel: NET: 27 messages suppressed.
Jan  2 12:27:18 fw01 kernel: Neighbour table overflow.
Quoted 4 lines

Once I disconnect the cable from the eth5 interface, I can ping to my router. I try to reconnect the cable back to the eth5 interface and run a ping to my router. As the result, I can't ping the router and the similar messages pops up in the /var/log/syslog file.

1) do you have a loopback interface up with the IP 127.0.0.1 on this machine?

2) do you > 1024 hosts plugged into this layer 2 broadcast domain?

3) are you plugging both ports of an ethernet bridge into the same layer 2 broadcast domain, creating a broadcast storm?

-j

--
"It is better to remain silent and thought a fool, than open your
mouth and remove all doubt."
--The Simpsons