Skip to contentSkip to conversation

dmesg output for Transcend 6-in-1 USB card reader

DISCUSSION Joakim Ziegler 1 participant 1 message Jan 19, 2005

lore
Share & tools
lore
#0 lore raw

I needed to make scsi_mod probe all luns on this device to be able to use it. After some Googling, it seems it's encouraged to send dmesg output to this list to get the device added to the list of devices which should have all luns probed automatically. If I'm mistaken about that, my apologies. dmesg output follows:

usb 2-1: new full speed USB device using address 8 scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: Model: USB Card Reader Rev: 1.0a
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
Vendor: Model: USB Card Reader Rev: 1.0a
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdc at scsi1, channel 0, id 0, lun 1
Vendor: Model: USB Card Reader Rev: 1.0a
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sde at scsi1, channel 0, id 0, lun 2
Vendor: Model: USB Card Reader Rev: 1.0a
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdf at scsi1, channel 0, id 0, lun 3 USB Mass Storage device found at 8

And /proc/bus/usb/devices:

T:  Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#=  8 Spd=12  MxCh= 0
D:  Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs=  1
P:  Vendor=0d7d ProdID=0240 Rev= 1.00
S:  Manufacturer=
S:  Product=USB Reader
S:  SerialNumber=30370A0030B9
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=350mA
I:  If#= 0 Alt= 0 #EPs= 3 Cls=08(stor.) Sub=06 Prot=50 Driver=usb-
storage
E:  Ad=81(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms
E:  Ad=02(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms
E:  Ad=83(I) Atr=03(Int.) MxPS=   2 Ivl=1ms

Hope this is useful. Not a member of the list, Cc: me on replies, etc.

Signature · 1 line
Joakim Ziegler <[email protected]>