Skip to contentSkip to conversation

HTTP Port-forwarding

DISCUSSION Rudi Starcevic 2 participants 2 messages Mar 1, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I have these rules below to enable:

a) http port-forwarding in requests
b) masquerading rules for http replies.

It does seem to work OK but is very slow. After hours of looking I think the problem as to why it is so slow may be in my Iptables rules.

Can you see a double up or something that may cause a problem ? Or would you say it all looks fine and my problem is elsewhere ?

Thank you ..

$IPTABLES -P INPUT DROP
$IPTABLES -P OUTPUT DROP
$IPTABLES -P FORWARD DROP

# http requests:
# Port-Forwarding setup
$IPTABLES -t nat -A PREROUTING -i $ETH0 -p tcp --dport 80 -d 66.xxx.xx.100 -j DNAT --to 192.168.0.10:80
# http replies:
# ENABLE NAT
echo "1" > /proc/sys/net/ipv4/ip_forward

# NAT Forwarding Setup
$IPTABLES --table nat --append POSTROUTING --out-interface $ETH0 -j MASQUERADE $IPTABLES -A FORWARD -i $ETH1 -j ACCEPT
$IPTABLES -A FORWARD -i $ETH0 -j ACCEPT
$IPTABLES -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT

Signature · 3 lines
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 266.5.1 - Release Date: 27/02/2005
#1 lore raw
Quoted 28 lines · Rudi Starcevic

Hi,

I have these rules below to enable:

a) http port-forwarding in requests
b) masquerading rules for http replies.

It does seem to work OK but is very slow. After hours of looking I think the problem as to why it is so slow may be in my Iptables rules.

Can you see a double up or something that may cause a problem ? Or would you say it all looks fine and my problem is elsewhere ?

Thank you ..

$IPTABLES -P INPUT DROP
$IPTABLES -P OUTPUT DROP
$IPTABLES -P FORWARD DROP

# http requests:
# Port-Forwarding setup
$IPTABLES -t nat -A PREROUTING -i $ETH0 -p tcp --dport 80 -d 
66.xxx.xx.100 -j DNAT --to 192.168.0.10:80
# http replies:
# ENABLE NAT
echo "1" > /proc/sys/net/ipv4/ip_forward
Quoted 6 lines

# NAT Forwarding Setup
$IPTABLES --table nat --append POSTROUTING --out-interface $ETH0 -j MASQUERADE
$IPTABLES -A FORWARD -i $ETH1 -j ACCEPT
$IPTABLES -A FORWARD -i $ETH0 -j ACCEPT
$IPTABLES -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT

you're basically not running a firewall at all--i would look elsewhere. the usual suspects:

* DNS resolution timing out
* Network interface speed/duplex mismatches

-j

--
"Another day, another box of stolen pens."
--The Simpsons